Instruction Manual

0458-004-0121-A
24
English 11 After Finishing Work
► Dose and use detergent as described in the instructions
for use of the detergent.
► Screw the cover onto the detergent bottle (3) and tighten
it by hand.
► Insert the detergent bottle (3) into the holder (1) on the
pressure washer.
► Rotate 3-in-1 nozzle into position and set the highest
power level.
11.1 When Work is Finished
► Switch off the high-pressure washer and pull the mains
plug out of the socket.
► If the high-pressure washer is connected to the water
supply: Turn off water supply.
► Press the spray gun trigger.
The water pressure is reduced.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the water
source.
► Remove the water hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the rest of the water run out
of the spray gun.
► Clean the high-pressure washer.
► Wind up the high-pressure hose (1) evenly distributed
over the reel.
► Coil the connecting cable (2) on the holder (3).
► Secure the connecting cable (2) using the clip (4).
► Insert the detergent bottle (5).
► Insert nozzle (6).
► Store the spray attachment in the holders (7) on the high-
pressure washer.
11.2 Protecting the pressure washer with antifreeze
If the pressure washer cannot be protected from frost during
transport or storage, the pressure washer should be
protected by a glycol-based antifreeze. The antifreeze
prevents water inside the pressure washer from freezing and
causing damage to the pressure washer.
► Remove spray lance
► Connect the shortest possible water hose to the pressure
washer.
The shorter the water hose, the less antifreeze is needed.
► Mix the antifreeze as described in the antifreeze
Instruction Manual.
► Pour antifreeze into a clean container.
► Insert water hose into container of antifreeze.
► Squeeze and hold spray gun trigger.
► Switch on pressure washer.
11 After Finishing Work
3
6
1
2
4
5
0000099068_001
7
7
7
7
7
0000098886_001