Instruction Manual

0458-004-0121-A
19
English 7 Connecting to a water source
► If the spray lance is attached to the spray gun: Remove
the spray lance.
► Squeeze the spray gun trigger until an even water jet is
delivered from the spray gun.
► Release the spray gun trigger.
► Lock the spray gun trigger.
► Attach the spray lance.
► Attach the nozzle.
Removing the water hose
► Turn off tap.
► To unlock the coupling: Pull the ring (1) or twist and hold it.
► Pull the coupling off the connector (2).
7.2 Connecting the high-pressure washer to
another water supply
The high-pressure washer can draw in water from water
butts, storage tanks and flowing or still rivers and lakes.
So that the water can be drawn in, the height difference
between the high-pressure washer and the water source
must not exceed the max. suction lift (a), @ 18.1.
The appropriate STIHL suction set must be used. The
suction set includes a water hose with a special coupling.
Depending on the market, the appropriate STIHL suction set
may be included with the high-pressure washer.
Connecting the water filter
If the high-pressure washer is operated with water
containing sand from water butts, cisterns or from flowing or
still rivers and lakes, a water filter must be connected to the
high-pressure washer.
Depending on the market, the water filter may be included
with the high-pressure washer.
► Unscrew the connector (1).
1
2
0000098891_001
a
0000098892_001
1
3
2
0000098893_001