Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 4.1 Warning Symbols
- 4.2 Intended Use
- 4.3 Requirements concerning the user
- 4.4 Clothing and equipment
- 4.5 Work area and surroundings
- 4.6 Safe condition
- 4.7 Working
- 4.8 Detergents
- 4.9 Connecting the water supply
- 4.10 Connecting to the power supply
- 4.11 Transport
- 4.12 Storage
- 4.13 Cleaning, Maintenance and Repair
- 4.14 Battery
- 5 Preparing the pressure washer for operation
- 6 Assembling the pressure washer
- 7 Connecting to a water source
- 8 Connecting the pressure washer to the power supply
- 9 Switching the pressure washer on and off
- 10 Operating the pressure washer
- 11 After Finishing Work
- 12 Transporting
- 13 Storing
- 14 Cleaning
- 15 Maintenance
- 16 Repairing
- 17 Troubleshooting
- 18 Specifications
- 19 Spare Parts and Accessories
- 20 Disposal
- 21 EC Declaration of Conformity
- 22 UKCA Declaration of Conformity
0458-004-0121-A
9
English
4 Safety Precautions
■ If the high-pressure washer starts behaving differently or
in an unusual way while operating, the high-pressure
washer may be in an unsafe condition. This may result in
serious injury to people and damage to property.
► Stop working, unplug the mains plug from the socket
and consult a STIHL dealer.
► The high-pressure washer must always be operated in
an upright position.
► To ensure an adequate exchange of cooling air, do not
cover the high-pressure washer.
■ When the spray gun trigger is released, the high-pressure
pump switches off automatically and water stops flowing
out of the nozzle. The high-pressure washer is then in
stand-by mode and is still switched on. If the spray gun
trigger is squeezed, the high-pressure pump switches on
again automatically and water flows out of the nozzle. This
may result in serious injury to people and damage to
property.
► When not operating the machine: Lock the spray gun
trigger.
► Unplug the mains plug of the high-pressure washer from
the socket.
■ At temperatures below 0° C water can freeze on the
surface to be cleaned and in the components of the high-
pressure washer. The user may slip, fall and be seriously
injured. Damage to property may occur.
► Do not use the high-pressure washer at temperatures
below 0° C.
■ Pulling on the high-pressure hose, water hose or
connecting cable can cause the high-pressure washer to
move and topple over. Damage to property may occur.
► Do not pull on the high-pressure hose, water hose or
connecting cable.
■ If the high-pressure washer is placed on a sloping, uneven
or soft surface it may move and topple over. Damage to
property may occur.
► Place the high-pressure washer on a horizontal, flat,
hard surface.
■ If working at a height, the high-pressure washer or the
spray attachment may fall to the ground. This may result
in serious injury to people and damage to property.
► Use a lift bucket or secure scaffolding.
► Do not place the high-pressure washer in a lift bucket or
on scaffolding.
► If the high-pressure hose does not have sufficient
reach: Extend the high-pressure hose by connecting a
high-pressure hose extension.
► Secure the spray attachment so that it cannot fall.
► Switch off the high-pressure washer.










