Instruction Manual

MSE 170 C, MSE 210 C
English
27
N Fit the chain – start at the bar nose.
Pay attention to the position of the
tensioning gear and the cutting
edges.
N Turn the tensioning gear (1)
clockwise as far as stop.
N Turn the guide bar so that the
tensioning gear is facing you.
N Fit the chain over the sprocket (2).
N Push the guide bar over the bar
stud (3), the head of the rear bar
stud must engage the slot.
N Make sure the drive link tangs
engage the bar groove (arrow) and
then rotate the tensioning gear
counterclockwise as far as stop.
N Place the chain sprocket cover in
position and engage the guide lugs
in the recesses in the handle
housing.
When fitting the chain sprocket cover,
check that the teeth of the tensioning
gear and adjusting wheel mesh properly.
N If necessary, turn the adjusting
wheel (4) slightly until the sprocket
cover can be pushed flush against
the handle housing.
N Pull the hinged handle (5) out until it
engages in the upright position.
N Fit the wingnut and tighten it
moderately – finally tighten the
wingnut by hand only after
tensioning the saw chain.
N Go to chapter on "Tensioning the
Saw Chain"
1
181BA012 KN
2
3
181BA013 KN
9931BA020 KN
9931BA021 KN
4
9931BA022 KN
5