Instruction Manual

13.4 Closing the filler cap
001BA252 KN
Grip must be vertical:
► Fit the cap – marks on filler cap and oil tank
must line up.
► Press the cap down as far as stop.
001BA253 KN
► While holding the cap depressed, turn it clock‐
wise until it engages in position.
001BA254 KN
The marks on the filler cap and oil tank are then
in alignment.
001BA235 KN
► Fold the grip down.
001BA255 KN
Filler cap is locked.
13.5 If the filler cap cannot be
locked in the oil tank opening
Bottom of cap is twisted in relation to top.
► Remove the cap from the oil tank and check it
from above.
1
001BA238 KN
Left: Bottom of cap is twisted – inner
mark (1) in line with outer mark.
Right: Bottom of cap in correct position –
inner mark is under the grip. It is not
in line with the outer mark.
001BA256 KN
► Place the cap on the opening and rotate it
counterclockwise until it engages the filler
neck.
► Continue rotating the cap counterclockwise
(about a quarter turn) – this causes the bottom
of the cap to be turned to the correct position.
13 Filling Chain Oil Tank English
0458-756-0121-B 21