Operators Manual

Table Of Contents
Clean the chainsaw with a damp cloth or
STIHL resin solvent.
Clean vents with a paintbrush.
Remove the chain sprocket cover.
Clean the area around the chain sprocket with
a damp cloth or STIHL resin solvent.
Remove foreign objects from the battery com‐
partment and clean the battery compartment
with a damp cloth.
Clean the electrical contacts in the battery
compartment with a paintbrush or soft brush.
Fit the chain sprocket cover.
17.2 Cleaning the Guide Bar and
Saw Chain
Switch off chainsaw, engage the chain brake
and remove the battery.
Remove the guide bar and saw chain.
1
2
3
3
0000-GXX-3212-A1
Clean the oil port (1), oil inlet hole (2) and bar
groove (3) with a soft brush or STIHL resin
solvent.
Clean the saw chain with a soft brush or
STIHL resin solvent.
Mount the guide bar and saw chain.
17.3 Cleaning the fleece air filter
Switch off chainsaw, engage the chain brake
and remove the battery.
1
2
3
4
0000098922_001
Turn the screws (1) counterclockwise until the
cover (2) can be removed.
Remove shroud (2).
Press the latch (3) and remove the air filter (4).
Dust down the air filter (4).
If the air filter (4) is damaged: Install a new air
filter (4).
From the clean side, blow off the air filter (4)
with compressed air.
WARNING
If detergents come into contact with the skin or
eyes, the skin or eyes may be irritated.
Observe the user manual for the detergent.
Avoid contact with detergents.
If skin contact occurs: Wash affected areas
of skin with plenty of water and soap.
If eye contact occurs: Flush eyes with
plenty of water for at least 15 minutes and
consult a doctor.
Spray the outside and inside of the air filter
(4) with STIHL special cleaner or a cleaning
agent with a pH value higher than 12.
Allow STIHL special cleaner or cleaning agent
to act for 10 minutes.
Rinse the clean side of the air filter (4) under
running water.
Rinse the dirty side of the air filter (4) under
running water.
Allow the air filter (4) to dry in the air.
4
5
6
0000098923_001
Position the air filter (4) so that the latch (5)
engages in the recess (6).
Close the air filter (4).
The air filter (4) audibly engages.
Fit the cover (2).
Insert screws (1) and tighten them.
17.4 Cleaning the Battery
Clean the battery with a damp cloth.
18 Maintenance
18.1 Maintenance intervals
Maintenance intervals depend on the ambient
conditions and the operating conditions. STIHL
recommends the following maintenance inter‐
vals:
Chain brake
18 Maintenance English
0458-007-9801-A 49