Instruction Manual

MSA 160 C, MSA 200 C
English
32
N If your cap i in the closed position:
with the filler cap in the filling neck,
twist it counterclockwise until it
drops into its seat.
N Continue to twist the filler cap
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position for
installation.
N While pushing down on the cap,
twist the filler cap clockwise and
close it – see section "Closing."
The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
The coasting brake stops the rotating
saw chain when the trigger switch is
released.
1 Coasting brake inactive
2 Coasting brake active
001BA239 KN
Checking Chain Lubrication
143BA024 KN
Coasting Brake
1
2
0000-GXX-4957-A0