Instruction Manual

For transport regulations see www.stihl.com/
safety-data-sheets
14 Storing
14.1 Storing the Chainsaw
► Switch off the chainsaw, engage the chain
brake and remove the battery.
► Fit the scabbard so that it completely covers
the guide bar.
► Observe the following points when storing the
saw:
–
Saw is out of the reach of children.
–
The saw is clean and dry.
► If you store the saw for more than 3 months:
Remove the bar and chain.
14.2 Storing the Battery
STIHL recommends that you store the battery
with a charge between 40% and 60% (2 LEDs
glow green).
► Observe the following points when storing the
battery:
–
Battery is out of the reach of children.
–
Battery is clean and dry.
–
Battery is in an enclosed space.
–
Store the battery separately from the saw
and charger.
–
Battery is in non-conductive packaging.
–
Battery is in a temperature range between
-10°C and +50°C.
15 Cleaning
15.1 Cleaning the chainsaw
► switch off chain saw, engage chain brake and
remove battery
► Clean the chainsaw with a damp cloth or
STIHL resin solvent.
► Clean vents with a paintbrush.
► Remove the chain sprocket cover.
► Clean the area around the chain sprocket with
a damp cloth or STIHL resin solvent.
► Remove foreign objects from the battery com‐
partment and clean the battery compartment
with a damp cloth.
► Clean the electrical contacts in the battery
compartment with a paintbrush or soft brush.
► Fit the chain sprocket cover.
15.2 Cleaning the Bar and Chain
► Switch off the chainsaw, engage the chain
brake and remove the battery.
► Remove the bar and chain.
1
2
3
3
0000-GXX-3107-A0
► Clean the oil port (1), oil inlet hole (2) and bar
groove (3) with a soft brush or STIHL resin
solvent.
► Clean the saw chain with a soft brush or
STIHL resin solvent.
► Mount the bar and chain.
15.3 Cleaning the Battery
► Clean the battery with a damp cloth.
16 Maintenance
16.1 Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
Chain brake
► Have the chain brake serviced by a STIHL
servicing dealer at the following intervals:
–
Full-time usage: every 3 months
–
Part-time usage: every 6 months
–
Occasional usage: every 12 months
Weekly
► Check the chain sprocket.
► Check and deburr the guide bar.
► Check and sharpen the saw chain.
Monthly
► Have the oil tank cleaned by a STIHL servic‐
ing dealer.
16.2 Deburring the Guide Bar
A burr can build up on the outer edge of the
guide bar.
► Remove burr with a flat file or a STIHL guide
bar dressing tool.
► If you have any queries: Contact your STIHL
servicing dealer.
16.3 Sharpening the Saw Chain
Correctly sharpening saw chains requires a lot of
practice.
English 14 Storing
50 0458-701-9821-G