Instruction Manual

–
Data connection: Bluetooth
®
5.1. The
mobile appliance must be compatible with
Bluetooth
®
Low Energy 5.0 and support
Generic Access Profile (GAP).
–
Frequency band: ISM band 2.4 GHz
–
Maximum RF power transmitted: 1 mW
–
Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
–
Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
21.5 Noise and Vibration Data
STIHL recommends that you wear hearing pro‐
tection.
–
Sound pressure level L
pA
measured according
to ISO 22868: 83 dB(A) K-value (uncertainty)
for noise pressure level is 2 dB(A).
–
Sound power level L
wA
measured according to
ISO 22868: 94 dB(A) K-value (uncertainty) for
sound power level is 2 dB(A).
–
Vibration level a
hv
measured according to
ISO 22867
–
Control handle: 2.2 m/s² K-value for vibra‐
tion level is 2 m/s².
–
Handlebar: 2.1 m/s² K-value (uncertainty)
for vibration level is 2 m/s².
The vibration values quoted above have been
measured according to a standardized test pro‐
cedure and may be used to compare electric
power tools. Depending on the type of usage,
the vibrations that actually occur may differ from
the values quoted. The vibration values quoted
may be used for an initial assessment of the
user's exposure to vibrations. The actual expo‐
sure to vibrations has to be estimated. This proc‐
ess may also take into account times during
which the electric power tool is switched off and
times during which it is switched on but running
off load.
21.6 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
22 Bar and Chain Combinations
22.1 STIHL MSA 161 T Chainsaw
Pitch Drive link
gauge/groove
width
Length Guide Bar Nose spro‐
cket teeth
Number of
drive links
Saw chain
1/4" P 1.1 mm
25 cm
Rollomatic E Mini 8
57
71 PM3 (Type
3670)
30 cm 65
The cutting length of a guide bar depends on the chainsaw and the saw chain being used. Actual cut‐
ting length may be less than the specified length
23 Spare Parts and Accesso‐
ries
23.1 Spare parts and accessories
These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.
24 Disposal
24.1 Disposing of Chainsaw and
Battery
Contact the local authorities or your STIHL
dealer for information on disposal.
Improper disposal can be harmful to health and
pollute the environment.
► Take STIHL products including packaging to a
suitable collection point for recycling in accord‐
ance with local regulations.
► Do not dispose with domestic waste.
22 Bar and Chain Combinations English
0458-791-9821-D 49