Operation Manual

MSA 160 T
English
67
Switching on the machine
N Assume a firm and secure stance
N Ensure that there are no other
persons within the swivel range of
the machine
N Hold the machine with both hands –
wrap hands tightly around the
handles
N Make certain that the saw chain has
not yet been positioned for cutting
and is not touching any other
objects
N Release the chain brake – pull the
hand guard toward the handlebar
(position ‚)
N Press and hold the trigger switch
lockout (1) and the trigger switch (2)
simultaneously
N Guide the machine into the wood
with the saw chain running
The motor will not run unless the hand
guard is set to ‚ and the trigger switch
lockout (1) and trigger switch (2) are
pressed at the same time.
Trigger switch
The motor speed can be controlled
using the trigger switch. The more the
trigger switch is depressed, the higher
the motor speed.
N During operation, check the level of
the chain oil tank frequently – see
"Filling chain oil"
Checking the chain tension
Check chain tension frequently
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period.
Chain cold
Tension is correct when the chain fits
snugly against the underside of the bar
but can still be pulled easily along the
bar by hand. Retension the saw chain if
necessary – see "Tensioning the Saw
Chain".
Chain at operating temperature
The chain stretches and begins to sag.
The drive links must not come out of the
bar groove on the underside of the bar –
the chain may otherwise jump off the
bar. Retension the saw chain – see
"Tensioning the Saw Chain"
After finishing work
N Set hand guard to ƒ
N Remove the battery from the
machine
N Slacken off the chain if you have
retensioned it at operating
temperature during work
9923BA006 KN
2
1
9923BA020 KN
Operating Instructions