Operation Manual

MSA 160 C
English
45
Battery
The machine can be used with STIHL
type AP batteries.
The running time of the machine
depends on the energy of the battery
(e. g., 80 Wh with AP 80 or 160 Wh with
AP 160).
Charger
Charging times
Chain lubrication
Fully automatic, speed-controlled oil
pump with reciprocating piston
Weight
Cutting attachment
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Observe the information about ANSI
standard B 175.1-2000 as well as the
definition "low-kickback saw chain" in
the section "Safety Precautions and
Working Techniques".
Guide bars Rollomatic E Mini
1/4" Picco
Saw chains 1/4" Picco
Chain sprocket
In order to comply with the kickback
performance requirements of Sec. 5.11
of ANSI standard B 175.1-2000, do not
use replacement saw chains unless they
have been designated as meeting the
ANSI Sec. 5.11 requirements on this
specific engine unit, or have been
designated as "low kickback" saw
chains in accordance with the ANSI
B 175.1-2000 standard.
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.
Specifications
Type: Lithium ion
AL 100
Mains voltage: 120 V
Rated current: 1.3 A
Frequency: 60 Hz
Power consumption: 75 W
Charging current: 1.6 A
Protection class: II, E (double
insulated)
AL 300
Mains voltage: 120 V
Rated current: 4.7 A
Frequency: 60 Hz
Power consumption: 330 W
Charging current: 6.5 A
Protection class: II, E (double
insulated)
AL 100
with AP 80:
– up to 80 % capacity: 70 min
– up to 100 % capacity: 100 min
with AP 160:
– up to 80 % capacity: 150 min
– up to 100 % capacity: 165 min
AL 300
with AP 80:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 50 min
with AP 160:
– up to 80 % capacity: 35 min
– up to 100 % capacity: 60 min
Oil tank capacity: 7.1 fl.oz (0.21 l)
With cutting attachment, without battery
MSA 160 C: 7.1 lbs. (3.2 kg)
Cutting length: 12 in. (30 cm)
Pitch: 1/4" P (6.35 mm)
Groove width:
0.043 in.
(1.1 mm)
Sprocket nose: 10-tooth
Picco Micro (71 PM3)
Pitch: 1/4" P (6.35 mm)
Drive link gauge: 0.043 in. (1.1 mm)
7-tooth for 1/4" P