Operation Manual

0458-727-9621-A
81
English 19 Troubleshooting
19.1 Troubleshooting Chainsaw or Battery
19 Troubleshooting
Condition LEDs on Battery Cause Remedy
Saw does not start
when switched on.
1 LED flashes
green
Battery has low charge ► Charge the battery.
1 LED glows red. Battery too hot or too cold. ► Engage the chain brake and remove the battery.
► Allow battery to cool down / warm up.
3 LEDs flash red. Malfunction in saw. ► Engage the chain brake and remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Disengage the chain brake.
► Switch on the saw.
► If 3 LEDs continue to flash red: Do not use your
chainsaw and contact your STIHL servicing dealer.
3 LEDs glow red Chainsaw is too hot. ► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down
4 LEDs flash red. There is a malfunction in
the battery.
► Engage the chain brake, remove and refit the
battery.
► Disengage the chain brake.
► Switch on the saw.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL servicing dealer.
No electrical contact
between the chainsaw and
battery.
► Remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
Saw or battery damp ► Allow saw or battery to dry
Saw cuts out during
operation
3 LEDs glow red Chainsaw is too hot. ► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down
There is a electrical
malfunction.
► Remove battery and insert it again.
► Switch on the saw.