Instruction Manual
Table Of Contents
- STIHL MSA 120 C, MSA 140 C
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 4.1 Warnsymbole
- 4.2 Bestimmungsgemäße Verwendung
- 4.3 Anforderungen an den Benutzer
- 4.4 Bekleidung und Ausstattung
- 4.5 Arbeitsbereich und Umgebung
- 4.6 Sicherheitsgerechter Zustand
- 4.7 Arbeiten
- 4.8 Reaktionskräfte
- 4.9 Laden
- 4.10 Elektrisch anschließen
- 4.11 Transportieren
- 4.12 Aufbewahren
- 4.13 Reinigen, Warten und Reparieren
- 5 Motorsäge einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Motorsäge zusammenbauen
- 8 Kettenbremse einlegen und lösen
- 9 Akku einsetzen und herausnehmen
- 10 Motorsäge einschalten und ausschalten
- 11 Motorsäge und Akku prüfen
- 12 Mit der Motorsäge arbeiten
- 13 Nach dem Arbeiten
- 14 Transportieren
- 15 Aufbewahren
- 16 Reinigen
- 17 Warten
- 18 Reparieren
- 19 Störungen beheben
- 20 Technische Daten
- 21 Kombinationen der Führungsschienen und Sägeketten
- 22 Ersatzteile und Zubehör
- 23 Entsorgen
- 24 EU-Konformitätserklärung
- 25 Anschriften
- 26 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the Saw for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Saw
- 8 Engaging and Disengaging the Chain Brake
- 9 Removing and Fitting the Battery
- 10 Switching the Saw On/Off
- 11 Testing the Chain Saw and Battery
- 12 Operating the Saw
- 13 After Finishing Work
- 14 Transporting
- 15 Storing
- 16 Cleaning
- 17 Maintenance
- 18 Repairing
- 19 Troubleshooting
- 20 Specifications
- 21 Bar and Chain Combinations
- 22 Spare Parts and Accessories
- 23 Disposal
- 24 EC Declaration of Conformity
- 25 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Forces de réaction
- 4.9 Recharge
- 4.10 Branchement électrique
- 4.11 Transport
- 4.12 Rangement
- 4.13 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation de la tronçonneuse
- 6 Recharge de la batterie et DEL
- 7 Assemblage de la tronçonneuse
- 8 Serrage et desserrage du frein de chaîne
- 9 Introduction et extraction de la batterie
- 10 Mise en marche et arrêt de la tronçonneuse
- 11 Contrôle de la tronçonneuse et de la batterie
- 12 Travail avec la tronçonneuse
- 13 Après le travail
- 14 Transport
- 15 Rangement
- 16 Nettoyage
- 17 Maintenance
- 18 Réparation
- 19 Dépannage
- 20 Caractéristiques techniques
- 21 Combinaisons de guide-chaînes et de chaînes de tronçonneuse
- 22 Pièces de rechange et accessoires
- 23 Mise au rebut
- 24 Déclaration de conformité UE
- 25 Indications générales de sécurité pour outils électroportatifs
- 25.1 Introduction
- 25.2 Sécurité à l'endroit de travail
- 25.3 Sécurité sur le plan électrique
- 25.4 Sécurité des personnes
- 25.5 Utilisation et emploi soigneux d'outils électroportatifs
- 25.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 25.7 Service après-vente
- 25.8 Consignes de sécurité applicables aux scies à chaîne / tronçonneuses
- 25.9 Causes d'un rebond, et comment les éviter
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Forze di reazione
- 4.9 Carica
- 4.10 Collegamento elettrico
- 4.11 Trasporto
- 4.12 Conservazione
- 4.13 Pulizia, manutenzione e riparazione
- 5 Preparare la motosega per l'esercizio
- 6 Carica della batteria e LED
- 7 Assemblaggio della motosega
- 8 Inserire e sbloccare il freno catena
- 9 Inserire e togliere la batteria
- 10 Accendere e spegnere la motosega
- 11 Controllo di motosega e batteria
- 12 Lavorare con la motosega
- 13 Dopo il lavoro
- 14 Trasporto
- 15 Conservazione
- 16 Pulizia
- 17 Manutenzione
- 18 Riparazione
- 19 Eliminazione dei guasti
- 20 Dati tecnici
- 21 Combinazioni di spranghe di guida e catene della sega
- 22 Ricambi e accessori
- 23 Smaltimento
- 24 Dichiarazione di conformità UE
- 25 Avvertenze di sicurezza generali per attrezzi elettrici
- 25.1 Introduzione
- 25.2 Sicurezza sul posto di lavoro
- 25.3 Sicurezza elettrica
- 25.4 Sicurezza delle persone
- 25.5 Impiego e maneggio dell’attrezzo elettrico
- 25.6 Impiego e trattamento dell’attrezzo a batteria
- 25.7 Assistenza
- 25.8 Avvertenze di sicurezza per le seghe a catena
- 25.9 Cause e prevenzione del rimbalzo
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Motorzaag klaarmaken voor gebruik
- 6 Accu laden en leds
- 7 Motorzaag completeren
- 8 Kettingrem inschakelen en lossen
- 9 Accu aanbrengen en wegnemen
- 10 Motorzaag inschakelen en uitschakelen
- 11 Kettingzaag en accu controleren
- 12 Met de motorzaag werken
- 13 Na de werkzaamheden
- 14 Vervoeren
- 15 Opslaan
- 16 Reinigen
- 17 Onderhoud
- 18 Repareren
- 19 Storingen opheffen
- 20 Technische gegevens
- 21 Combinaties van zaagbladen en zaagkettingen
- 22 Onderdelen en toebehoren
- 23 Milieuverantwoord afvoeren
- 24 EU-conformiteitsverklaring
- 25 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
- 25.1 Inleiding
- 25.2 Veiligheid op de werkplek
- 25.3 Elektrische veiligheid
- 25.4 Veiligheid van personen
- 25.5 Gebruik en behandeling van het elektrische gereedschap
- 25.6 Gebruik en behandeling van het accugereedschap
- 25.7 Service
- 25.8 Veiligheidsinstructies voor kettingzagen
- 25.9 Oorzaak en voorkomen van een terugslag
MSA 140 C
STIHL recommends wearing ear defenders.
–
Sound pressure level L
pA
measured according
to EN 60745‑2‑13: 83 dB(A)
–
Sound power level L
wA
measured according to
EN 60745-2-13: 94 dB(A)
–
Vibration level a
hv
measured according to
EN 60745-2-13:
–
Control handle: 4.8 m/s²
–
Front handle: 4.3 m/s².
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times when the electric power tool is
switched off and the times when it is switched on
but running under no load can be taken into
account in the estimate.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
20.8 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
21 Bar and Chain Combinations
21.1 STIHL MSA 120 C, MSA 140 C Chainsaws
Pitch Drive link
gauge/groove
width
Length Guide bar Nose spro‐
cket teeth
Number of
drive links
Saw chain
1/4" P 1.1 mm
25 cm Rollomatic E Mini
8
56
71 PM3 (Type
3670)
30 cm Rollomatic E Mini 64
The cutting length of a guide bar depends on the chainsaw and the saw chain being used. Actual cut‐
ting length may be less than the specified length
22 Spare Parts and Accesso‐
ries
22.1 Spare parts and accessories
These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.
23 Disposal
23.1 Disposal of Chain Saw, Battery
and Charger
Contact your STIHL servicing dealer for informa‐
tion on disposal.
► Dispose of the saw, guide bar, saw chain, bat‐
tery, charger, accessories and packaging in
accordance with local regulations and environ‐
mental requirements.
24 EC Declaration of Con‐
formity
24.1 STIHL MSA 120 C, MSA 140 C
Chainsaws
ANDREAS STIHL AG & Co. KG
Badstraße 115
D-71336 Waiblingen
Germany
declare under our sole responsibility that
–
Category: Cordless chainsaw
–
Manufacturer's brand: STIHL
–
Model: MSA 120 C, Serial identification: 1254
–
Model: MSA 140 C, Serial identification: 1254
conforms to the specifications of Directives
2011/65/EU, 2006/42/EC, 2014/30/EU and
2000/14/EC and has been developed and built in
compliance with the versions of the following
standards valid at the production date:
21 Bar and Chain Combinations English
0458-716-9621-D 61