Instruction Manual
Table Of Contents
- STIHL MSA 120 C, MSA 140 C
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 4.1 Warnsymbole
- 4.2 Bestimmungsgemäße Verwendung
- 4.3 Anforderungen an den Benutzer
- 4.4 Bekleidung und Ausstattung
- 4.5 Arbeitsbereich und Umgebung
- 4.6 Sicherheitsgerechter Zustand
- 4.7 Arbeiten
- 4.8 Reaktionskräfte
- 4.9 Laden
- 4.10 Elektrisch anschließen
- 4.11 Transportieren
- 4.12 Aufbewahren
- 4.13 Reinigen, Warten und Reparieren
- 5 Motorsäge einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Motorsäge zusammenbauen
- 8 Kettenbremse einlegen und lösen
- 9 Akku einsetzen und herausnehmen
- 10 Motorsäge einschalten und ausschalten
- 11 Motorsäge und Akku prüfen
- 12 Mit der Motorsäge arbeiten
- 13 Nach dem Arbeiten
- 14 Transportieren
- 15 Aufbewahren
- 16 Reinigen
- 17 Warten
- 18 Reparieren
- 19 Störungen beheben
- 20 Technische Daten
- 21 Kombinationen der Führungsschienen und Sägeketten
- 22 Ersatzteile und Zubehör
- 23 Entsorgen
- 24 EU-Konformitätserklärung
- 25 Anschriften
- 26 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the Saw for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Saw
- 8 Engaging and Disengaging the Chain Brake
- 9 Removing and Fitting the Battery
- 10 Switching the Saw On/Off
- 11 Testing the Chain Saw and Battery
- 12 Operating the Saw
- 13 After Finishing Work
- 14 Transporting
- 15 Storing
- 16 Cleaning
- 17 Maintenance
- 18 Repairing
- 19 Troubleshooting
- 20 Specifications
- 21 Bar and Chain Combinations
- 22 Spare Parts and Accessories
- 23 Disposal
- 24 EC Declaration of Conformity
- 25 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Forces de réaction
- 4.9 Recharge
- 4.10 Branchement électrique
- 4.11 Transport
- 4.12 Rangement
- 4.13 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation de la tronçonneuse
- 6 Recharge de la batterie et DEL
- 7 Assemblage de la tronçonneuse
- 8 Serrage et desserrage du frein de chaîne
- 9 Introduction et extraction de la batterie
- 10 Mise en marche et arrêt de la tronçonneuse
- 11 Contrôle de la tronçonneuse et de la batterie
- 12 Travail avec la tronçonneuse
- 13 Après le travail
- 14 Transport
- 15 Rangement
- 16 Nettoyage
- 17 Maintenance
- 18 Réparation
- 19 Dépannage
- 20 Caractéristiques techniques
- 21 Combinaisons de guide-chaînes et de chaînes de tronçonneuse
- 22 Pièces de rechange et accessoires
- 23 Mise au rebut
- 24 Déclaration de conformité UE
- 25 Indications générales de sécurité pour outils électroportatifs
- 25.1 Introduction
- 25.2 Sécurité à l'endroit de travail
- 25.3 Sécurité sur le plan électrique
- 25.4 Sécurité des personnes
- 25.5 Utilisation et emploi soigneux d'outils électroportatifs
- 25.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 25.7 Service après-vente
- 25.8 Consignes de sécurité applicables aux scies à chaîne / tronçonneuses
- 25.9 Causes d'un rebond, et comment les éviter
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Forze di reazione
- 4.9 Carica
- 4.10 Collegamento elettrico
- 4.11 Trasporto
- 4.12 Conservazione
- 4.13 Pulizia, manutenzione e riparazione
- 5 Preparare la motosega per l'esercizio
- 6 Carica della batteria e LED
- 7 Assemblaggio della motosega
- 8 Inserire e sbloccare il freno catena
- 9 Inserire e togliere la batteria
- 10 Accendere e spegnere la motosega
- 11 Controllo di motosega e batteria
- 12 Lavorare con la motosega
- 13 Dopo il lavoro
- 14 Trasporto
- 15 Conservazione
- 16 Pulizia
- 17 Manutenzione
- 18 Riparazione
- 19 Eliminazione dei guasti
- 20 Dati tecnici
- 21 Combinazioni di spranghe di guida e catene della sega
- 22 Ricambi e accessori
- 23 Smaltimento
- 24 Dichiarazione di conformità UE
- 25 Avvertenze di sicurezza generali per attrezzi elettrici
- 25.1 Introduzione
- 25.2 Sicurezza sul posto di lavoro
- 25.3 Sicurezza elettrica
- 25.4 Sicurezza delle persone
- 25.5 Impiego e maneggio dell’attrezzo elettrico
- 25.6 Impiego e trattamento dell’attrezzo a batteria
- 25.7 Assistenza
- 25.8 Avvertenze di sicurezza per le seghe a catena
- 25.9 Cause e prevenzione del rimbalzo
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Motorzaag klaarmaken voor gebruik
- 6 Accu laden en leds
- 7 Motorzaag completeren
- 8 Kettingrem inschakelen en lossen
- 9 Accu aanbrengen en wegnemen
- 10 Motorzaag inschakelen en uitschakelen
- 11 Kettingzaag en accu controleren
- 12 Met de motorzaag werken
- 13 Na de werkzaamheden
- 14 Vervoeren
- 15 Opslaan
- 16 Reinigen
- 17 Onderhoud
- 18 Repareren
- 19 Storingen opheffen
- 20 Technische gegevens
- 21 Combinaties van zaagbladen en zaagkettingen
- 22 Onderdelen en toebehoren
- 23 Milieuverantwoord afvoeren
- 24 EU-conformiteitsverklaring
- 25 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
- 25.1 Inleiding
- 25.2 Veiligheid op de werkplek
- 25.3 Elektrische veiligheid
- 25.4 Veiligheid van personen
- 25.5 Gebruik en behandeling van het elektrische gereedschap
- 25.6 Gebruik en behandeling van het accugereedschap
- 25.7 Service
- 25.8 Veiligheidsinstructies voor kettingzagen
- 25.9 Oorzaak en voorkomen van een terugslag
► Do not leave the battery unattended.
► Make sure that children cannot play with
the battery.
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain ambient conditions, it may catch fire or
explode. This can result in serious injuries and
damage to property.
► Protect battery from heat and fire.
► Do not throw the battery into a fire.
► Use and store the battery at temper‐
atures between ‑ 10 °C and + 50 °C.
► Protect the battery from rain and
damp – do not immerse it in fluids.
► Keep battery away from metallic objects.
► Do not expose battery to high pressure.
► Do not expose battery to microwaves.
► Protect battery from chemicals and salts.
4.5.3 Charger
WARNING
■ Bystanders, children and animals are not
aware of and cannot assess the dangers of a
charger or electric current. Bystanders, chil‐
dren and animals may be seriously or fatally
injured.
►
Keep bystanders, children and animals
away from the work area.
►Make sure that children can‐
not play with the charger.
■
The charger is not waterproof. If you work in
the rain or in a damp environment, an electric
shock may occur. The user may be injured
and the charger may be damaged.
► Do not operate it in the rain or in a
damp environment.
■ The charger is not protected against all ambi‐
ent conditions. If the charger is exposed to
certain ambient conditions, it may catch fire or
explode. This may result in serious injury to
people and damage to property.
►
Operate the charger in an enclosed, dry
room.
► Do not operate the charger in a flammable
environment or in an explosive environ‐
ment.
►
Do not operate the charger on a readily
combustible surface.
► Use and store the charger at temperatures
between + 5 °C and + 40 °C.
■ The connecting cable is a trip hazard. People
may be injured and the charger may be dam‐
aged.
►
Lay the connecting cable flat on the floor.
4.6 Safe Condition
4.6.1 Chainsaw
The chainsaw is in a safe condition if the follow‐
ing points are observed:
–
The chainsaw is not damaged.
–
The saw is clean and dry.
–
The chain catcher is not damaged.
–
The chain brake is operating properly.
–
The controls function properly and have not
been modified.
–
The chain lubrication is operating properly.
–
Wear marks on the chain sprocket are not
deeper than 0.5 mm.
–
A combination of guide bar and saw chain rec‐
ommended in this User Manual is mounted.
–
The guide bar and saw chain are properly
mounted.
–
The saw chain is properly tensioned.
–
Only original STIHL accessories designed for
this chainsaw model are fitted.
–
The accessories are correctly attached.
–
The oil tank cap is closed.
WARNING
■
If not in safe condition, components may no
longer operate correctly and safety devices
may be disabled. This may result in serous or
fatal injury to people.
►
Work only with an undamaged chainsaw.
► If the saw is dirty or wet: Clean the saw and
allow it to dry.
► Work only with an undamaged chain
catcher.
► Never modify your chainsaw. Exception:
Mounting a combination of guide bar and
saw chain recommended in this User Man‐
ual.
►
If the controls do not function properly: Do
not use your chainsaw.
► Only fit original STIHL accessories
designed for this chainsaw model.
► Mount the guide bar and saw chain as
described in this User Manual.
► Attach accessories as described in this
User Manual or in the User Manual for the
accessories.
English 4 Safety Precautions
40 0458-716-9621-D