Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Kickback and Other Reactive Forces
- 8 Proper Techniques for Basic Bucking, Limbing, Pruning and Felling
- 9 Battery Safety
- 10 Charger Safety
- 11 Maintenance, Repair and Storage
- 12 Before Starting Work
- 13 Charging the Battery
- 14 LED Diagnostics
- 15 Assembling the Chain Saw
- 16 The Chain Brake
- 17 Inserting and Removing the Battery
- 18 Switching the Chain Saw On and Off
- 19 Checking the Chain Saw
- 20 After Finishing Work
- 21 Transporting the Chain Saw and Battery
- 22 Storing the Chain Saw, Battery and Charger
- 23 Cleaning
- 24 Inspection and Maintenance
- 25 Troubleshooting Guide
- 26 Specifications
- 27 Combinations of Guide Bars and Saw Chains
- 28 Replacement Parts and Equipment
- 29 Disposal
- 30 Limited Warranty
- 31 Trademarks
- 32 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 5.1 Introducción
- 5.2 Seguridad en la zona de trabajo
- 5.3 Seguridad eléctrica
- 5.4 Seguridad personal
- 5.5 Uso y cuidado de la herramienta eléctrica
- 5.6 Uso y cuidado de la herramienta de baterías
- 5.7 Mantenimiento
- 5.8 Advertencias de seguridad generales para motosierras
- 5.9 Causas del contragolpe y medidas de prevención
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Contragolpe y otras fuerzas reactivas
- 8 Técnicas adecuadas para el tronzado, el desramado, la poda y la tala básicos
- 9 Seguridad de la batería
- 10 Seguridad del cargador
- 11 Mantenimiento, reparación y almacenamiento
- 12 Antes de empezar a trabajar
- 13 Carga de la batería
- 14 Diagnóstico de LED
- 15 Armado de la motosierra
- 16 El freno de cadena
- 17 Colocación y extracción de la batería.
- 18 Encendido y apagado de la motosierra
- 19 Revisión de la motosierra
- 20 Después de completar el trabajo
- 21 Transporte de la motosierra y de la batería
- 22 Almacenamiento de la motosierra, de la batería y del cargador
- 23 Limpieza
- 24 Inspección y mantenimiento
- 25 Guía de solución de problemas
- 26 Especificaciones
- 26.1 STIHL MSA 120 C, MSA 140 C
- 26.2 Piñones de cadena
- 26.3 Profundidad de ranura mínima para las espadas
- 26.4 Ajuste de calibrador de profundidad
- 26.5 Batería STIHL serie AK
- 26.6 STIHL AL 101
- 26.7 Símbolos de la motosierra, de la batería y del cargador
- 26.8 Mejoramientos técnicos
- 26.9 Declaración de cumplimiento con norma FCC 15
- 27 Combinaciones de espadas y cadenas de aserrado
- 28 Piezas y equipos de repuesto
- 29 Eliminación
- 30 Garantía limitada
- 31 Marcas comerciales
- 32 Direcciones
0458-716-8621-E
48
English
22 Storing the Chain Saw, Battery and Charger
When transporting the battery:
► Place the battery in a non-metal container or carton and
secure it against impact or damage. Never transport the
battery in a metal or other container that is capable of
conducting electricity, or near metal objects (e.g., paper
clips, nails, coins, keys).
► If you are transporting the battery in a vehicle, secure it
and its container to prevent turnover, impact and damage.
STIHL batteries comply with the requirements set forth in
UN-Manual ST/SG/AC.10/11/Rev.5/Part III, Subsection
38.3.
Commercial air, vessel and ground transportation of lithium
ion cells and batteries is regulated. The battery is classified
as a UN 3480, Class 9, packaging group II product. Shipping
it, either as a complete tool or the battery, requires
compliance with all applicable shipping regulations. Check
with the ground, vessel, air cargo or passenger airline to
determine if transport is prohibited or subject to restrictions
or exemptions prior to shipping or travel.
Normally, no further conditions have to be met by the user in
order to transport STIHL batteries by road to the power tool's
operating site. Check and comply with any special
regulations that may apply to your situation.
For further information please go to www.stihlusa.com/
battery-transportation-safety.
22.1 Chain Saw
WARNING
Store the chain saw indoors in a dry, secure place that
cannot be accessed by children or other unauthorized users,
@ 6.4. Never store the battery in the chain saw or charger.
Improper storage can result in unauthorized use and
damage to the chain saw, @ 6.4.
When storing the saw for three months or longer:
► Remove any wood chips or debris from the battery
compartment.
► Remove the chain and guide bar.
► Clean and spray the guide bar with a resin solvent, such
as STIHL Resin Remover and Lubricant.
► Clean the saw, @ 23.1.
► Fill up the chain oil tank, @ 15.4.2.
► Store the saw indoors in a dry and secure location, out of
the reach of children and other unauthorized persons.
22.2 Battery
WARNING
To reduce the risk of a short circuit, which could lead to
electric shock, fire and explosion, never store the battery in
a metal container or near metal objects, @ 9. If the battery
is damp or wet, allow it to dry thoroughly before storing,
@ 9.
WARNING
High temperatures can damage the battery and result in loss
of performance and a shortened battery life. It may also
cause the battery to generate heat, rupture, leak, ignite or
explode, resulting in severe or fatal personal injury or
property damage. Use and store the battery only within an
ambient temperature range of 14 °F to 122 °F (- 10 °C to
50 °C), @ 9. Never store the battery in direct sunlight or
inside a vehicle in hot weather, @ 9.
To properly store the battery:
► Take the battery out of the chain saw or the charger.
► Make sure the battery is dry and store it indoors in a dry
and secure location.
► Keep it out of the reach of children and other unauthorized
persons.
► Protect the battery against dampness and corrosive
agents such as garden chemicals and de-icing salts.
22 Storing the Chain Saw, Battery and
Charger