Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Kickback and Other Reactive Forces
- 8 Proper Techniques for Basic Bucking, Limbing, Pruning and Felling
- 9 Battery Safety
- 10 Charger Safety
- 11 Maintenance, Repair and Storage
- 12 Before Starting Work
- 13 Charging the Battery
- 14 LED Diagnostics
- 15 Assembling the Chain Saw
- 16 The Chain Brake
- 17 Inserting and Removing the Battery
- 18 Switching the Chain Saw On and Off
- 19 Checking the Chain Saw
- 20 After Finishing Work
- 21 Transporting the Chain Saw and Battery
- 22 Storing the Chain Saw, Battery and Charger
- 23 Cleaning
- 24 Inspection and Maintenance
- 25 Troubleshooting Guide
- 26 Specifications
- 27 Combinations of Guide Bars and Saw Chains
- 28 Replacement Parts and Equipment
- 29 Disposal
- 30 Limited Warranty
- 31 Trademarks
- 32 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 5.1 Introducción
- 5.2 Seguridad en la zona de trabajo
- 5.3 Seguridad eléctrica
- 5.4 Seguridad personal
- 5.5 Uso y cuidado de la herramienta eléctrica
- 5.6 Uso y cuidado de la herramienta de baterías
- 5.7 Mantenimiento
- 5.8 Advertencias de seguridad generales para motosierras
- 5.9 Causas del contragolpe y medidas de prevención
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Contragolpe y otras fuerzas reactivas
- 8 Técnicas adecuadas para el tronzado, el desramado, la poda y la tala básicos
- 9 Seguridad de la batería
- 10 Seguridad del cargador
- 11 Mantenimiento, reparación y almacenamiento
- 12 Antes de empezar a trabajar
- 13 Carga de la batería
- 14 Diagnóstico de LED
- 15 Armado de la motosierra
- 16 El freno de cadena
- 17 Colocación y extracción de la batería.
- 18 Encendido y apagado de la motosierra
- 19 Revisión de la motosierra
- 20 Después de completar el trabajo
- 21 Transporte de la motosierra y de la batería
- 22 Almacenamiento de la motosierra, de la batería y del cargador
- 23 Limpieza
- 24 Inspección y mantenimiento
- 25 Guía de solución de problemas
- 26 Especificaciones
- 26.1 STIHL MSA 120 C, MSA 140 C
- 26.2 Piñones de cadena
- 26.3 Profundidad de ranura mínima para las espadas
- 26.4 Ajuste de calibrador de profundidad
- 26.5 Batería STIHL serie AK
- 26.6 STIHL AL 101
- 26.7 Símbolos de la motosierra, de la batería y del cargador
- 26.8 Mejoramientos técnicos
- 26.9 Declaración de cumplimiento con norma FCC 15
- 27 Combinaciones de espadas y cadenas de aserrado
- 28 Piezas y equipos de repuesto
- 29 Eliminación
- 30 Garantía limitada
- 31 Marcas comerciales
- 32 Direcciones
0458-716-8621-E
36
English
13 Charging the Battery
13.1 Setting up the Charger
WARNING
Read and follow the battery and charger safety precautions
and instructions in this manual, @ 9 and @ 10. To reduce
the risk of short circuit, which could lead to electric shock,
fire and explosion, make sure the charger and its
components are dry and not damaged; operate the charger
indoors at an appropriate ambient temperature, @ 10.
WARNING
Since the battery and charger heat up during the charging
process, do not operate the charger on a combustible
surface or in a location where combustible gases, liquids,
vapors, dusts or other materials and substances are
present, @ 10.
To set up the charger:
► Insert the plug (3) into a properly installed wall outlet (4)
matching the voltage and electrical frequency stated on
the rating plate on the charger.
The charger runs a self-test immediately after it is plugged
in. The charger LED (1) will glow green for about 1 second,
then it will glow red briefly before going out. Once the LED
goes out, the self-test is complete and the charger is ready
to charge the battery.
► Position the power supply cord (2) so that it will not be
stepped on, tripped over, come in contact with sharp
objects or moving parts or otherwise present a tripping
hazard or be subjected to damage or stress.
13.2 Charging
WARNING
STIHL batteries contain safety features and devices which,
if damaged, may allow the battery to generate heat, rupture,
leak, ignite or explode. Never charge a malfunctioning,
damaged, cracked, leaking or deformed battery. For indoor
use only. Keep the charger dry. Protect it from rain, water,
liquids and damp conditions. Never insert a wet battery.
Never use a wet charger, @ 10.
To charge the battery:
► Push the battery (2) into the charger (3) until it stops.
The LED on the charger (4) glows green when the battery
is charging.
The LEDs (1) on the battery glow green and show the
state of charge.
When the LEDs on the battery turn off, the charging
process is complete and the charger will shut itself off.
► Remove the battery from the charger and disconnect the
power supply cord from the electrical outlet when charging
is complete.
13 Charging the Battery
3
2
1
2
0000-GXX-0636-A1
4
3
2
4
1
0000-GXX-0637-A0