Instruction Manual

0458-716-8621-E
8
English 5 General Power Tool Safety Warnings
e)Do not use a battery pack or tool that is damaged or
modified. Damaged or modified batteries may exhibit
unpredictable behaviour resulting in fire/explosion or risk
of injury.
f) Do not expose a battery pack or tool to fire or excessive
temperature. Exposure to fire or temperatures above
100 °C may cause explosion.
g)Follow all charging instructions and do not charge the
battery pack or tool outside the temperature range
specified in the instructions. Charging improperly or at
temperatures outside the specified range may damage the
battery and increase the risk of fire.
5.7 Service
a)Have your power tool serviced by a qualified repair person
using only identical replacement parts. This will ensure
that the safety of the power tool is maintained.
b)Never service damaged battery packs. Service of battery
packs should only be performed by the manufacturer or
authorized service provider.
5.8 General Chain Saw Safety Warnings
a)Keep all parts of the body away from the saw chain when
the chain saw is operating. Before you start the chain saw,
make sure the saw chain is not contacting anything. A
moment of inattention while operating chain saws may
cause entanglement of your clothing or body with the saw
chain.
b)Always hold the chain saw with your right hand on the rear
handle and your left hand on the front handle. Holding the
chain saw with the reversed hand configuration increases
the risk of personal injury and should never be done.
c) Hold the chain saw by insulated gripping surfaces only,
because the saw chain may contact hidden wiring. Saw
chain contacting a "live" wire may make exposed metal
parts of the chain saw "live" and could give the operator
an electric shock.
d)Wear eye protection. Further protective equipment for
hearing, head, hands, legs and feet is recommended.
Adequate protective equipment will reduce personal injury
from flying debris and or accidental contact with the saw
chain.
e)Do not operate a chain saw in a tree, on a ladder, from a
rooftop, or any unstable support. Operation of a chain saw
in this manner could result in serious personal injury.
f) Always keep proper footing and operate the chain saw
only when standing on fixed, secure and level surface.
Slippery or unstable surfaces may cause a loss of balance
or control of the chain saw.
g)When cutting a limb that is under tension, be alert for
spring back. When the tension in the wood fibers is
released, the spring loaded limb may strike the operator
and/or throw the chain saw out of control.
h)Use extreme caution when cutting brush and saplings.
The slender material may catch the saw chain and be
whipped toward you or pull you off balance.
i) Carry the chain saw by the front handle with the chain saw
switched off and away from your body. When transporting
or storing the chain saw, always fit the guide bar cover.
Proper handling of the chain saw will reduce the likelihood
of accidental contact with the moving saw chain.
j) Follow instructions for lubricating, chain tensioning and
changing the bar and chain. Improperly tensioned or
lubricated chain may either break or increase the chance
for kickback.
k) Cut wood only. Do not use chain saw for purposes not
intended. For example: do not use chain saw for cutting
metal, plastic, masonry or non-wood building materials.
Use of the chain saw for operations different than intended
could result in a hazardous situation.
l) Do not attempt to fell a tree until you have an
understanding of the risks and how to avoid them. Serious
injury could occur to the operator or bystanders while
felling a tree.