Instruction Manual

0000-GXX-1250-A0
► If the wood is sound and long-fibered:
Observe the following points when making
sapwood cuts:
–
The cuts must be the same at both sides.
–
The cuts must be at the same height as the
bottom of the felling notch.
–
The width of the cuts is 1/10 of the trunk
diameter.
The trunk does not splinter when the tree falls.
12.4.4 Basic information on felling cut
Ø
1/10
0000-GXX-1251-A1
C
C
E
G
C Felling notch
The felling notch determines the direction of
fall.
D Hinge
The hinge helps control the falling tree. The
width of the hinge is 1/10 of the trunk diame‐
ter.
E Felling cut
The tree is felled with the felling cut. The fell‐
ing cut is 1/10 of the trunk diameter (at least 3
cm) above the bottom of the felling notch.
F Stabilizing strap
The stabilizing strap supports the tree and
helps prevent it from falling prematurely. The
width of the stabilizing strap is 1/10 to 1/5 of
the trunk diameter.
G Holding strap
The holding strap supports the tree and helps
prevent it from falling prematurely. The width
of the holding strap is 1/10 to 1/5 of the trunk
diameter.
12.4.5 Plunge cutting
Plunge cutting is a technique required for felling.
1
2
3
0000-GXX-4449-A0
► Begin cut with the lower portion of the guide
bar nose – with chain running at full speed.
► Cut until depth of kerf is twice the width of the
guide bar.
► Swing the saw into plunge-cutting position.
► Perform the plunge cut.
12.4.6 Selecting the Appropriate Felling Cut
The choice of appropriate felling cut depends on
the following conditions:
–
The natural inclination of the tree
–
The tree’s branch formation
–
Damage to the tree
–
The tree’s state of health
–
If there is snow on the tree: the snow load
–
The direction of slope
–
Wind direction and speed
–
Nearby trees, if any
There are different features of these conditions.
Only two features are described in this Instruc‐
tion Manual.
0000-GXX-1253-A0
1
2
1 Normal tree
A normal tree is vertical and has an even
crown.
2 Leaner
A leaner stands at an angle and the crown
faces in the direction of fall.
12.4.7 Felling normal, small diameter tree
A normal tree is felled with a felling cut and stabi‐
lizing strap. This felling cut must be performed if
the tree diameter is less than the guide bar’s
length.
► Shout a warning.
English 12 Operating the Saw
54 0458-716-9621-D