Instruction Manual

► If the LED on the right flashes green: Charge
the battery.
6.4 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.
Malfunction in chainsaw or battery.
6.5 LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7 Assembling the Saw
7.1 Mounting and Removing the
Bar and Chain
7.1.1 Mounting the Bar and Chain
The bar and chain combinations that can be
used with the chain sprocket are listed in the
specifications,
21.
► Switch off the chain saw, engage the chain
brake and remove the battery.
0000-GXX-1199-A0
1
3
2
► Raise the grip (1) of the wingnut (2).
► Rotate the wingnut (2) counterclockwise until
the chain sprocket cover (3) can be removed.
► Remove the chain sprocket cover (3).
4
4
5
0000-GXX-1200-A0
5
6
► Remove the tensioning gear (4).
► Take out the screw (5).
► Place the guide bar (6) on the tensioning gear
(4) so that both pegs on the tensioning gear
(4) engage the holes in the guide bar.
The guide bar (6) may be either way round. The
logo on the guide bar may also be upside down.
► Insert and tighten down the screw (5).
4
0000-GXX-1201-A0
► Fit the chain in the bar groove so that the
arrows on the tie straps on top of the bar point
in the direction of rotation.
► Turn the tensioning gear (4) clockwise as far
as stop.
3
2
0000-GXX-1202-A0
4
6
► Fit the guide bar with tensioning gear and
chain on the saw and check the following
points:
–
The tensioning gear (4) faces the user.
–
Chain drive links are seated in teeth of
chain sprocket (2).
–
Head of screw (3) locates in slot in guide
bar (6).
English 7 Assembling the Saw
48 0458-716-9621-D