Instruction Manual
Table Of Contents
- STIHL MSA 120 C, MSA 140 C
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 4.1 Warnsymbole
- 4.2 Bestimmungsgemäße Verwendung
- 4.3 Anforderungen an den Benutzer
- 4.4 Bekleidung und Ausstattung
- 4.5 Arbeitsbereich und Umgebung
- 4.6 Sicherheitsgerechter Zustand
- 4.7 Arbeiten
- 4.8 Reaktionskräfte
- 4.9 Laden
- 4.10 Elektrisch anschließen
- 4.11 Transportieren
- 4.12 Aufbewahren
- 4.13 Reinigen, Warten und Reparieren
- 5 Motorsäge einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Motorsäge zusammenbauen
- 8 Kettenbremse einlegen und lösen
- 9 Akku einsetzen und herausnehmen
- 10 Motorsäge einschalten und ausschalten
- 11 Motorsäge und Akku prüfen
- 12 Mit der Motorsäge arbeiten
- 13 Nach dem Arbeiten
- 14 Transportieren
- 15 Aufbewahren
- 16 Reinigen
- 17 Warten
- 18 Reparieren
- 19 Störungen beheben
- 20 Technische Daten
- 21 Kombinationen der Führungsschienen und Sägeketten
- 22 Ersatzteile und Zubehör
- 23 Entsorgen
- 24 EU-Konformitätserklärung
- 25 Anschriften
- 26 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the Saw for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Saw
- 8 Engaging and Disengaging the Chain Brake
- 9 Removing and Fitting the Battery
- 10 Switching the Saw On/Off
- 11 Testing the Chain Saw and Battery
- 12 Operating the Saw
- 13 After Finishing Work
- 14 Transporting
- 15 Storing
- 16 Cleaning
- 17 Maintenance
- 18 Repairing
- 19 Troubleshooting
- 20 Specifications
- 21 Bar and Chain Combinations
- 22 Spare Parts and Accessories
- 23 Disposal
- 24 EC Declaration of Conformity
- 25 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Forces de réaction
- 4.9 Recharge
- 4.10 Branchement électrique
- 4.11 Transport
- 4.12 Rangement
- 4.13 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation de la tronçonneuse
- 6 Recharge de la batterie et DEL
- 7 Assemblage de la tronçonneuse
- 8 Serrage et desserrage du frein de chaîne
- 9 Introduction et extraction de la batterie
- 10 Mise en marche et arrêt de la tronçonneuse
- 11 Contrôle de la tronçonneuse et de la batterie
- 12 Travail avec la tronçonneuse
- 13 Après le travail
- 14 Transport
- 15 Rangement
- 16 Nettoyage
- 17 Maintenance
- 18 Réparation
- 19 Dépannage
- 20 Caractéristiques techniques
- 21 Combinaisons de guide-chaînes et de chaînes de tronçonneuse
- 22 Pièces de rechange et accessoires
- 23 Mise au rebut
- 24 Déclaration de conformité UE
- 25 Indications générales de sécurité pour outils électroportatifs
- 25.1 Introduction
- 25.2 Sécurité à l'endroit de travail
- 25.3 Sécurité sur le plan électrique
- 25.4 Sécurité des personnes
- 25.5 Utilisation et emploi soigneux d'outils électroportatifs
- 25.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 25.7 Service après-vente
- 25.8 Consignes de sécurité applicables aux scies à chaîne / tronçonneuses
- 25.9 Causes d'un rebond, et comment les éviter
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Forze di reazione
- 4.9 Carica
- 4.10 Collegamento elettrico
- 4.11 Trasporto
- 4.12 Conservazione
- 4.13 Pulizia, manutenzione e riparazione
- 5 Preparare la motosega per l'esercizio
- 6 Carica della batteria e LED
- 7 Assemblaggio della motosega
- 8 Inserire e sbloccare il freno catena
- 9 Inserire e togliere la batteria
- 10 Accendere e spegnere la motosega
- 11 Controllo di motosega e batteria
- 12 Lavorare con la motosega
- 13 Dopo il lavoro
- 14 Trasporto
- 15 Conservazione
- 16 Pulizia
- 17 Manutenzione
- 18 Riparazione
- 19 Eliminazione dei guasti
- 20 Dati tecnici
- 21 Combinazioni di spranghe di guida e catene della sega
- 22 Ricambi e accessori
- 23 Smaltimento
- 24 Dichiarazione di conformità UE
- 25 Avvertenze di sicurezza generali per attrezzi elettrici
- 25.1 Introduzione
- 25.2 Sicurezza sul posto di lavoro
- 25.3 Sicurezza elettrica
- 25.4 Sicurezza delle persone
- 25.5 Impiego e maneggio dell’attrezzo elettrico
- 25.6 Impiego e trattamento dell’attrezzo a batteria
- 25.7 Assistenza
- 25.8 Avvertenze di sicurezza per le seghe a catena
- 25.9 Cause e prevenzione del rimbalzo
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Motorzaag klaarmaken voor gebruik
- 6 Accu laden en leds
- 7 Motorzaag completeren
- 8 Kettingrem inschakelen en lossen
- 9 Accu aanbrengen en wegnemen
- 10 Motorzaag inschakelen en uitschakelen
- 11 Kettingzaag en accu controleren
- 12 Met de motorzaag werken
- 13 Na de werkzaamheden
- 14 Vervoeren
- 15 Opslaan
- 16 Reinigen
- 17 Onderhoud
- 18 Repareren
- 19 Storingen opheffen
- 20 Technische gegevens
- 21 Combinaties van zaagbladen en zaagkettingen
- 22 Onderdelen en toebehoren
- 23 Milieuverantwoord afvoeren
- 24 EU-conformiteitsverklaring
- 25 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
- 25.1 Inleiding
- 25.2 Veiligheid op de werkplek
- 25.3 Elektrische veiligheid
- 25.4 Veiligheid van personen
- 25.5 Gebruik en behandeling van het elektrische gereedschap
- 25.6 Gebruik en behandeling van het accugereedschap
- 25.7 Service
- 25.8 Veiligheidsinstructies voor kettingzagen
- 25.9 Oorzaak en voorkomen van een terugslag
► Engage the chain brake.
► Fit the scabbard so that it completely cov‐
ers the guide bar.
► Store the saw out of the reach of children.
■ Dampness can corrode the electrical contacts
on the saw and metal components. This can
damage the saw.
► Remove the battery.
► Store the saw in a clean and dry condition.
4.12.2 Battery
WARNING
■ Children are not aware of and cannot assess
the dangers of the battery and can be seri‐
ously injured.
►
Store the battery out of the reach of chil‐
dren.
■ The battery is not protected against all ambi‐
ent conditions. The battery may be damaged if
it is exposed to certain ambient conditions.
►
Store the battery in a clean and dry condi‐
tion.
► Store the battery in an enclosed location.
► Store the battery separately from the chain
saw and charger.
► Store the battery in non-conductive packag‐
ing.
► Store the battery at temperatures
between -10°C and +50°C.
4.12.3 Charger
WARNING
■
Children are not aware of and cannot assess
the dangers of a charger. Children may sus‐
tain serious or fatal injuries.
►
Remove the battery.
► Store the charger out of the reach of chil‐
dren.
■ The charger is not protected against all ambi‐
ent conditions. The charger may be damaged
if it is exposed to certain ambient conditions.
►
Remove the battery.
► If the charger is hot: Allow charger to cool
down.
► Store the charger in a clean and dry condi‐
tion.
► Store the charger in an enclosed location.
► Store the charger at a temperature between
+5°C and +40°C.
■ The connecting cable must not be used for
carrying or hanging up the charger. The con‐
necting cable and the charger may be dam‐
aged.
► Hold the charger by the housing. A
recessed handle is provided on the back of
the charger.
►
Hang the charger on the wall bracket.
4.13 Cleaning, Maintenance and
Repair
WARNING
■ The saw may start unintentionally if the battery
is left in place during cleaning, maintenance or
repair operations. This may result in serious
injury to people and damage to property.
► Remove the battery.
► Engage the chain brake.
■ Aggressive cleaning agents, a water jet or
pointed objects can damage the chainsaw,
guide bar, the saw chain. the battery and the
charger. If the saw, guide bar, saw chain, bat‐
tery or charger are not cleaned correctly, com‐
ponents may no longer function properly or
safety devices may be rendered inoperative.
They may cause serious injury to persons.
► Clean the saw, guide bar, saw chain, bat‐
tery and charger as described in this
instruction manual.
■
If the saw, guide bar, saw chain, battery or
charger are not properly serviced, components
may no longer function properly or safety devi‐
ces may be rendered inoperative. This may
result in serous or fatal injury to people.
►
Do not attempt to service or repair the saw,
battery or charger.
► If the saw, battery or the charger require
servicing or repairs: Contact your STIHL
servicing dealer for assistance.
►
Service or repair the guide bar and saw
chain as described in this User Manual.
■ The user may be cut by the sharp cutters
while cleaning or servicing the saw chain. This
may result in injury to the user.
►
Wear work gloves made from resistant
material.
5 Preparing the Saw for
Operation
5.1 Preparing the Saw for Opera‐
tion
Perform the following steps before starting work:
English
5 Preparing the Saw for Operation
46 0458-716-9621-D