Instruction Manual
Table Of Contents
- STIHL MSA 120 C, MSA 140 C
- 1 Vorwort
- 2 Informationen zu dieser Gebrauchsanleitung
- 3 Übersicht
- 4 Sicherheitshinweise
- 4.1 Warnsymbole
- 4.2 Bestimmungsgemäße Verwendung
- 4.3 Anforderungen an den Benutzer
- 4.4 Bekleidung und Ausstattung
- 4.5 Arbeitsbereich und Umgebung
- 4.6 Sicherheitsgerechter Zustand
- 4.7 Arbeiten
- 4.8 Reaktionskräfte
- 4.9 Laden
- 4.10 Elektrisch anschließen
- 4.11 Transportieren
- 4.12 Aufbewahren
- 4.13 Reinigen, Warten und Reparieren
- 5 Motorsäge einsatzbereit machen
- 6 Akku laden und LEDs
- 7 Motorsäge zusammenbauen
- 8 Kettenbremse einlegen und lösen
- 9 Akku einsetzen und herausnehmen
- 10 Motorsäge einschalten und ausschalten
- 11 Motorsäge und Akku prüfen
- 12 Mit der Motorsäge arbeiten
- 13 Nach dem Arbeiten
- 14 Transportieren
- 15 Aufbewahren
- 16 Reinigen
- 17 Warten
- 18 Reparieren
- 19 Störungen beheben
- 20 Technische Daten
- 21 Kombinationen der Führungsschienen und Sägeketten
- 22 Ersatzteile und Zubehör
- 23 Entsorgen
- 24 EU-Konformitätserklärung
- 25 Anschriften
- 26 Allgemeine Sicherheitshinweise für Elektrowerkzeuge
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the Saw for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Saw
- 8 Engaging and Disengaging the Chain Brake
- 9 Removing and Fitting the Battery
- 10 Switching the Saw On/Off
- 11 Testing the Chain Saw and Battery
- 12 Operating the Saw
- 13 After Finishing Work
- 14 Transporting
- 15 Storing
- 16 Cleaning
- 17 Maintenance
- 18 Repairing
- 19 Troubleshooting
- 20 Specifications
- 21 Bar and Chain Combinations
- 22 Spare Parts and Accessories
- 23 Disposal
- 24 EC Declaration of Conformity
- 25 General Power Tool Safety Warnings
- 1 Préface
- 2 Informations concernant la présente Notice d'emploi
- 3 Vue d'ensemble
- 4 Prescriptions de sécurité
- 4.1 Symboles d'avertissement
- 4.2 Utilisation conforme à la destination prévue
- 4.3 Exigences posées à l'utilisateur
- 4.4 Vêtements et équipement
- 4.5 Aire de travail et voisinage
- 4.6 Bon état pour une utilisation en toute sécurité
- 4.7 Utilisation
- 4.8 Forces de réaction
- 4.9 Recharge
- 4.10 Branchement électrique
- 4.11 Transport
- 4.12 Rangement
- 4.13 Nettoyage, entretien et réparation
- 5 Préparatifs avant l'utilisation de la tronçonneuse
- 6 Recharge de la batterie et DEL
- 7 Assemblage de la tronçonneuse
- 8 Serrage et desserrage du frein de chaîne
- 9 Introduction et extraction de la batterie
- 10 Mise en marche et arrêt de la tronçonneuse
- 11 Contrôle de la tronçonneuse et de la batterie
- 12 Travail avec la tronçonneuse
- 13 Après le travail
- 14 Transport
- 15 Rangement
- 16 Nettoyage
- 17 Maintenance
- 18 Réparation
- 19 Dépannage
- 20 Caractéristiques techniques
- 21 Combinaisons de guide-chaînes et de chaînes de tronçonneuse
- 22 Pièces de rechange et accessoires
- 23 Mise au rebut
- 24 Déclaration de conformité UE
- 25 Indications générales de sécurité pour outils électroportatifs
- 25.1 Introduction
- 25.2 Sécurité à l'endroit de travail
- 25.3 Sécurité sur le plan électrique
- 25.4 Sécurité des personnes
- 25.5 Utilisation et emploi soigneux d'outils électroportatifs
- 25.6 Utilisation et emploi soigneux d'outils électroportatifs sans fil
- 25.7 Service après-vente
- 25.8 Consignes de sécurité applicables aux scies à chaîne / tronçonneuses
- 25.9 Causes d'un rebond, et comment les éviter
- 1 Premessa
- 2 Informazioni sulle presenti Istruzioni d’uso
- 3 Sommario
- 4 Avvertenze di sicurezza
- 4.1 Simboli di avvertimento
- 4.2 Impiego secondo la destinazione
- 4.3 Requisiti dell'utente
- 4.4 Abbigliamento ed equipaggiamento
- 4.5 Zona di lavoro e area circostante
- 4.6 Condizioni di sicurezza
- 4.7 Impiego
- 4.8 Forze di reazione
- 4.9 Carica
- 4.10 Collegamento elettrico
- 4.11 Trasporto
- 4.12 Conservazione
- 4.13 Pulizia, manutenzione e riparazione
- 5 Preparare la motosega per l'esercizio
- 6 Carica della batteria e LED
- 7 Assemblaggio della motosega
- 8 Inserire e sbloccare il freno catena
- 9 Inserire e togliere la batteria
- 10 Accendere e spegnere la motosega
- 11 Controllo di motosega e batteria
- 12 Lavorare con la motosega
- 13 Dopo il lavoro
- 14 Trasporto
- 15 Conservazione
- 16 Pulizia
- 17 Manutenzione
- 18 Riparazione
- 19 Eliminazione dei guasti
- 20 Dati tecnici
- 21 Combinazioni di spranghe di guida e catene della sega
- 22 Ricambi e accessori
- 23 Smaltimento
- 24 Dichiarazione di conformità UE
- 25 Avvertenze di sicurezza generali per attrezzi elettrici
- 25.1 Introduzione
- 25.2 Sicurezza sul posto di lavoro
- 25.3 Sicurezza elettrica
- 25.4 Sicurezza delle persone
- 25.5 Impiego e maneggio dell’attrezzo elettrico
- 25.6 Impiego e trattamento dell’attrezzo a batteria
- 25.7 Assistenza
- 25.8 Avvertenze di sicurezza per le seghe a catena
- 25.9 Cause e prevenzione del rimbalzo
- 1 Voorwoord
- 2 Informatie met betrekking tot deze handleiding
- 3 Overzicht
- 4 Veiligheidsinstructies
- 5 Motorzaag klaarmaken voor gebruik
- 6 Accu laden en leds
- 7 Motorzaag completeren
- 8 Kettingrem inschakelen en lossen
- 9 Accu aanbrengen en wegnemen
- 10 Motorzaag inschakelen en uitschakelen
- 11 Kettingzaag en accu controleren
- 12 Met de motorzaag werken
- 13 Na de werkzaamheden
- 14 Vervoeren
- 15 Opslaan
- 16 Reinigen
- 17 Onderhoud
- 18 Repareren
- 19 Storingen opheffen
- 20 Technische gegevens
- 21 Combinaties van zaagbladen en zaagkettingen
- 22 Onderdelen en toebehoren
- 23 Milieuverantwoord afvoeren
- 24 EU-conformiteitsverklaring
- 25 Algemene veiligheidswaarschuwingen voor elektrische gereedschappen
- 25.1 Inleiding
- 25.2 Veiligheid op de werkplek
- 25.3 Elektrische veiligheid
- 25.4 Veiligheid van personen
- 25.5 Gebruik en behandeling van het elektrische gereedschap
- 25.6 Gebruik en behandeling van het accugereedschap
- 25.7 Service
- 25.8 Veiligheidsinstructies voor kettingzagen
- 25.9 Oorzaak en voorkomen van een terugslag
► Make sure the line voltage and frequency
agree with the data on the charger’s rating
plate.
■
A carelessly laid connecting or extension
cable can be damaged and cause others to
trip or fall. This can result in injuries and may
damage the connecting cable or extension
cable.
►
Position and mark connecting cable and
extension cable so they do not represent a
trip hazard.
►
Position the connecting and extension
cables so that they are not under tension or
entangled.
►
Position the connecting and extension
cables so that they cannot be damaged,
kinked, pinched or chafed.
►
Protect the connecting cable and extension
cable from heat, oil and chemicals.
► Lay the connecting and extension cables on
a dry surface.
■ The extension cable becomes hot during oper‐
ation. If the heat cannot dissipate, it may
cause a fire.
►
If you use a cable drum: Unwind the exten‐
sion cable to its full length.
■ If electric cables or pipes are embedded in the
wall, they may be damaged when the charger
is mounted on a wall. Contact with electric
cables can result in an electric shock. This can
result in serious injuries and damage to prop‐
erty.
►
Check that there are no electric cables or
pipes embedded in the wall.
■ If the charger is not mounted on the wall as
described in this instruction manual, the
charger or the battery may fall down or the
charger may overheat. This may result in per‐
sonal injuries and damage to property.
►
Mount the charger on the wall as described
in this instruction manual.
■ If the charger is mounted on a wall with the
battery inserted, the battery may fall out and
be damaged. This may result in personal inju‐
ries and damage to property.
►
Mount the charger on the wall first and then
insert the battery.
4.11 Transporting
4.11.1 Chainsaw
WARNING
■
The saw may turn over or shift during trans‐
port. This may result in personal injuries and
damage to property.
► Remove the battery.
► Engage the chain brake.
► Fit the scabbard so that it completely cov‐
ers the guide bar.
► Secure the chainsaw with lashing straps or
a net to prevent it turning over and moving.
4.11.2 Battery
WARNING
■ The battery is not protected against all ambi‐
ent conditions. The battery may be damaged if
it is exposed to certain ambient conditions and
damage to property may occur.
►
Never transport a damaged battery.
► Store the battery in non-conductive packag‐
ing.
■ The battery may turn over or shift during trans‐
port. This may result in personal injuries and
damage to property.
►
Pack the battery in packaging in such a way
that it cannot move.
► Secure the packaging so that it cannot
move.
4.11.3 Charger
WARNING
■
The charger may turn over or move while
being transported. This may result in personal
injuries and damage to property.
►
Disconnect the plug from the wall outlet.
► Remove the battery.
► Secure the charger with lashing straps,
belts or a net to prevent it turning over and
moving.
■
The connecting cable must not be used for
carrying the charger. The connecting cable
and the charger may be damaged.
►
Wind up the connecting cable and attach it
to the charger.
4.12 Storing
4.12.1 Chainsaw
WARNING
■
Children are not aware of and cannot assess
the dangers of a chainsaw and can be seri‐
ously injured.
► Remove the battery.
4 Safety Precautions English
0458-716-9621-D 45