Instruction Manual

► Always cut with the chain running at full
speed.
4.8.2 Pull-in
0000-GXX-1348-A0
The saw is pulled away from the operator when
the bottom of the bar is used for cutting.
WARNING
■ If the rotating chain makes contact with a hard
object and is suddenly pinched, the saw is
abruptly jerked away from the operator. The
operator can lose control of the saw and be
seriously or fatally injured.
►
Hold the saw firmly with both hands.
► Operate the saw as described in this
instruction manual.
► Keep the guide bar straight in the cut.
► Apply the spiked bumper properly.
► Always cut with the chain running at full
speed.
4.8.3 Pushback
0000-GXX-1349-A0
The saw is pushed back toward the operator
when the top of the bar is used for cutting.
WARNING
■
If the rotating chain makes contact with a hard
object and is suddenly pinched, the saw can
be abruptly pushed back toward the operator.
The operator can lose control of the saw and
be seriously or fatally injured.
►
Hold the saw firmly with both hands.
► Operate the saw as described in this
instruction manual.
► Keep the guide bar straight in the cut.
► Always cut with the chain running at full
speed.
4.9 Charging
WARNING
■
A damaged or defective charger may produce
an unusual smell or emit smoke during the
charging process. This may result in personal
injuries and damage to property.
►
Disconnect the plug from the wall outlet.
■ The charger can overheat and cause a fire if
heat dissipation is inadequate. This can result
in serious or fatal injuries and damage to prop‐
erty.
►
Do not cover the charger.
4.10 Connecting to Power Supply
Contact with live components may occur for the
following reasons:
–
The connecting cable or extension cable is
damaged.
–
Connecting cable plug or extension cable is
damaged.
–
Wall outlet is not properly installed.
DANGER
■ Contact with live components can result in an
electric shock. This can result in serious or
fatal injuries.
►
Check that the connecting cable, extension
cable and their plugs are not damaged.
If the connecting cable or extension
cable is damaged:
► Do not touch damaged areas.
► Disconnect the plug from the wall
outlet.
►
Never touch the connecting cable, exten‐
sion cable or their plugs with wet hands.
► Insert the plug of the connecting cable or
extension cable in a properly installed fused
wall outlet with ground contact.
►
Install the charger with a ground fault circuit
interrupter (30 mA, 30 ms).
■ A damaged or unsuitable extension cable can
cause an electric shock. This can result in
serious or fatal injuries.
►
Use an extension cable with the correct
wire gauge, 20.6.
WARNING
■
Overvoltage can occur in the charger if the line
voltage or frequency are incorrect during
charging. The charger may be damaged.
English 4 Safety Precautions
44 0458-716-9621-D