Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Products
- 5 General Power Tool Safety Warnings
- 6 IMPORTANT SAFETY INSTRUCTIONS
- 7 Kickback and Other Reactive Forces
- 8 Proper Techniques for Basic Bucking, Limbing, Pruning and Felling
- 9 Battery Safety
- 10 Charger Safety
- 11 Maintenance, Repair and Storage
- 12 Before Starting Work
- 13 Charging the Battery
- 14 LED Diagnostics
- 15 Assembling the Chain Saw
- 16 The Chain Brake
- 17 Inserting and Removing the Battery
- 18 Switching the Chain Saw On and Off
- 19 Checking the Chain Saw
- 20 After Finishing Work
- 21 Transporting the Chain Saw and Battery
- 22 Storing the Chain Saw, Battery and Charger
- 23 Cleaning
- 24 Inspection and Maintenance
- 25 Troubleshooting Guide
- 26 Specifications
- 27 Combinations of Guide Bars and Saw Chains
- 28 Replacement Parts and Equipment
- 29 Disposal
- 30 Limited Warranty
- 31 Trademarks
- 32 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en los productos
- 5 Advertencias generales de seguridad para herramientas motorizadas
- 5.1 Introducción
- 5.2 Seguridad en la zona de trabajo
- 5.3 Seguridad eléctrica
- 5.4 Seguridad personal
- 5.5 Uso y cuidado de la herramienta eléctrica
- 5.6 Uso y cuidado de la herramienta de baterías
- 5.7 Mantenimiento
- 5.8 Advertencias de seguridad generales para motosierras
- 5.9 Causas del contragolpe y medidas de prevención
- 6 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 7 Contragolpe y otras fuerzas reactivas
- 8 Técnicas adecuadas para el tronzado, el desramado, la poda y la tala básicos
- 9 Seguridad de la batería
- 10 Seguridad del cargador
- 11 Mantenimiento, reparación y almacenamiento
- 12 Antes de empezar a trabajar
- 13 Carga de la batería
- 14 Diagnóstico de LED
- 15 Armado de la motosierra
- 16 El freno de cadena
- 17 Colocación y extracción de la batería.
- 18 Encendido y apagado de la motosierra
- 19 Revisión de la motosierra
- 20 Después de completar el trabajo
- 21 Transporte de la motosierra y de la batería
- 22 Almacenamiento de la motosierra, de la batería y del cargador
- 23 Limpieza
- 24 Inspección y mantenimiento
- 25 Guía de solución de problemas
- 26 Especificaciones
- 26.1 STIHL MSA 120 C, MSA 140 C
- 26.2 Piñones de cadena
- 26.3 Profundidad de ranura mínima para las espadas
- 26.4 Ajuste de calibrador de profundidad
- 26.5 Batería STIHL serie AK
- 26.6 STIHL AL 101
- 26.7 Símbolos de la motosierra, de la batería y del cargador
- 26.8 Mejoramientos técnicos
- 26.9 Declaración de cumplimiento con norma FCC 15
- 27 Combinaciones de espadas y cadenas de aserrado
- 28 Piezas y equipos de repuesto
- 29 Eliminación
- 30 Garantía limitada
- 31 Marcas comerciales
- 32 Direcciones
0458-716-8621-E
56
English
25 Troubleshooting Guide
25.2 Charger
Useful life of battery
has been reached or
exceeded.
► Have the battery checked by an authorized STIHL servicing
dealer.
During sawing, the
wood smokes or
smells burnt.
The chain is dull or
improperly
sharpened.
► Properly sharpen the chain, @ 24.
Working technique is
improper or the saw
is being mis-used.
► Obtain instruction on proper working technique.
Insufficient bar and
chain oil.
► Have the chain lubrication mechanism checked by an
authorized STIHL servicing dealer.
Battery is not being
charged even though
LED on charger
glows green.
1 LED glows
red.
Battery too hot / too
cold.
► Allow the battery to warm up or cool down gradually at
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
► Operate the charger only in enclosed, dry rooms at ambient
temperatures of 41 °F to 104 °F (5 °C to 40 °C).
Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Battery
Possible Cause Remedy
Condition LEDs on
Charger
Cause Remedy
LED on charger
flashes red.
LED flashes
red.
No electrical contact
between charger and
battery.
► Remove the battery and reinsert it into the charger.
Malfunction in
battery.
► Remove the battery and reinsert it into the charger.
► If the LED continues to flash, do not attempt to charge.
If 4 LEDs on the battery are flashing, it has a malfunction
and must be replaced. Otherwise, have the battery checked
by an authorized STIHL servicing dealer.
Malfunction in
charger.
► Have the charger checked by an authorized STIHL
servicing dealer.