Operation Manual

35MS 441
English / USA
Starting Procedure
: Press in the button to open the
decompression valve.
The decompression valve closes as
soon as the engine fires.
: For this reason you must press in
the button before each starting
attempt.
: Observe safety precautions
: Push hand guard (1) forward:
The chain is now locked.
: Press down the trigger interlock (2)
and pull the throttle trigger (3) at the
same time.
Set Master Control lever (4) to:
for cold start l
for warm start n
(after engine has been running for
about one minute).
: Place your saw on the ground.
Make sure you have a firm footing –
check that chain is not touching any
object or the ground.
Bystanders must be well clear of the
general work area of the saw!
: Hold the saw firmly on the ground
with your left hand on the front
handle – your thumb should be
under the handle.
: Put your right foot into the rear
handle and press down.
Starting / Stopping
the Engine
STOP
0