Operation Manual

34
English / USA
MS 441
Fitting Cover Plate
(special accessory)
: Place the cover plate (1) in position,
and engage the two tabs (arrows).
Secure the cover plate with the
screws (2).
When the cover plate is fitted, the
shutter must be in the winter position.
: If your saw is very cold (frost or ice
on machine), start the engine and
keep it at a high idle speed (with
chain brake disengaged) until it
reaches normal operating
temperature.
In the event of engine running problems,
first check that conditions for use of the
cover plate still apply.
Switching on electric handle heating
(Special accessory)
: Move switch to # –
move switch back to O to switch off
the heating.
There is no risk of overheating during
long periods of operation.
The whole heating system is
maintenance-free.
The four positions of the
Master Control lever
0 = Engine off –
ignition is switched off.
# = Normal run position –
engine runs or can fire.
To move the Master Control lever from #
to
n or l, press down the throttle
trigger interlock and squeeze throttle
trigger at the same time.
n=Warm start – this position is used to
start a warm engine. The Master
Control lever moves to the normal
run position as soon as the throttle
trigger is squeezed.
l=Cold start – this position is used to
start a cold engine.
Electric Handle
Heating
Information
Before You Start
STOP
0
001BA140 KN