Operation Manual

MS 193 T
English
32
N Pull the hand guard toward the
control handle to disengage the
chain brake.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
N After a cold start, warm up the
engine at varying speeds – your saw
is ready for operation.
At very low outside temperatures
If idling behavior is erratic or
acceleration is poor:
N Readjust carburetor if necessary,
see "Adjusting the Carburetor".
N If your saw is very cold (frost or ice
on machine), start the engine and
keep it at a high idle speed (with
chain brake disengaged) until it
reaches normal operating
temperature.
Stopping the engine
N Move Master Control lever to
Stop 0.
If engine does not start
If you did not move the Master Control
lever from the choke closed
position (l) to the choke open
position (j) quickly enough after the
engine began to fire, the engine is
probably flooded.
N Move Master Control lever to
Stop 0.
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Crank the engine several times with
the starter to clear the combustion
chamber.
N Refit the spark plug – see "Spark
Plug".
N Set Master Control lever to the
starting throttle position (n) – even
if the engine is cold.
N Now start the engine.
If fuel tank has been run completely dry
and then refueled
N Press manual fuel pump bulb at
least ten times.
N Set the Master Control lever to the
starting throttle position (n).
N Move the choke lever to the closed
position (l)
N Give the starter rope one pull.
N Move the choke lever to the open
position (j).
N Now start the engine.
467BA006 KN
467BA010 KN