Operation Manual

MS 193 T
English
31
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Starting the Saw
WARNING
Bystanders must be well clear of the
general work area of the saw.
N Press the manual fuel pump bulb at
least ten times – even if the bulb is
already filled with fuel.
N Push the hand guard (1) forward –
the chain is locked.
N Press down the trigger lockout (2)
and pull the throttle trigger (3) at the
same time. Set Master Control
lever (4) to starting throttle
position (n).
N Set choke lever to required position.
Choke shutter closed (l)
– if the engine is cold (also use this
position if the engine stopped when
you opened the throttle after
starting)
Choke shutter open (j)
– if the engine is warm, i.e. if it has
been running for about one minute.
N Hold and start your saw as
described.
When engine begins to fire
N Move the choke lever to the open
position (j).
N Hold and start your saw as
described.
As soon as the engine runs
N Press down trigger lockout and the
blip the throttle trigger (3) – the
Master Control lever (4) moves to
the run position (F) and the engine
settles down to idling speed.
467BA007 KN
5
467BA008 KN
5
467BA009 KN
5
467BA009 KN