Operators Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Safety Precautions
- 3. Specifications
- 4. Troubleshooting
- 5. Cutting Attachment
- 6. Clutch
- 7. Chain Brake
- 8. Engine
- 9. Ignition System
- 10. Rewind Starter
- 11. Servicing the AV System
- 12. Master Control Lever
- 13. Chain Lubrication
- 14. Fuel System
- 15. Special Servicing Tools
- 16. Servicing Aids
97MS 171, MS 181, MS 211
– Coat the grommet with STIHL
Press Fluid, b 16
: Press the grommet (1) into the
bore (arrow) until it is properly
seated.
: Push the connector (1) into the
grommet and locate it on the web
(arrow).
533RA397 TG
1
533RA414 TG
1
: Push the fuel hose (1) onto the
connector (arrow).
– Install the manual fuel pump (if
standard), b 14.8.3
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
533RA191 TG
1
14.9.4 Fuel Tank Cap
See instruction manual.
– Open the tank cap.
: Disconnect the nipple inside the
tank (arrow).
– Check the tank cap and replace
sealing ring or tank cap.
– Install in the reverse sequence.
– Carry out leakage test.
533RA203 TG