Operators Manual
Table Of Contents
- Contents
- 1. Introduction
- 2. Safety Precautions
- 3. Specifications
- 4. Troubleshooting
- 5. Cutting Attachment
- 6. Clutch
- 7. Chain Brake
- 8. Engine
- 9. Ignition System
- 10. Rewind Starter
- 11. Servicing the AV System
- 12. Master Control Lever
- 13. Chain Lubrication
- 14. Fuel System
- 15. Special Servicing Tools
- 16. Servicing Aids
71MS 171, MS 181, MS 211
Check correct installed position.
: Insert the valve in the housing
bore (arrow).
: Use a 6 mm drift to carefully drive
in the new valve from outside –
note installed depth.
: Installed depth of valve:
a = about 2.5 mm
– Reassemble all other parts in the
reverse sequence.
533RA293 TG
533RA294 TG
219RA479 TG
13.5 Oil Tank Cap
See instruction manual.
– Open the tank cap.
: Disconnect the nipple inside the
tank (arrow).
– Inspect the tank cap and replace
sealing ring or the cap.
– Install in the reverse sequence.
– Carry out leakage test.
533RA187 TG