Operators Manual

MS 170, MS 170 C, MS 180, MS 180 C
English
20
N Remove screw(2)
N Position tensioning gear(1) and
guide bar(3) relative to one another
N Insert and tighten screw(2)
Releasing the chain brake
N Pull hand guard towards the front
handle until it engages audibly –
chain brake is released
Fitting the saw chain
WARNING
Put on protective gloves – risk of injury
by the sharp cutters.
N Fit the saw chain – starting at the
nose of the guide bar – pay attention
to the position of the tensioning gear
and the cutting edges
N Turn tensioning gear(1) to the right
as far as possible
N Turn the guide bar so that the
tensioning gear faces the user
N Place the saw chain on the chain
sprocket(2)
N Slide the guide bar over the collar
screw(3); the head of the rear collar
screw must protrude into the oblong
hole
2310BA015 KN
2
1
3
2310BA016 KN
2
2310BA017 KN
001BA186 KN
1
181BA012 KN
2
3
181BA013 KN