Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Product
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Kickback and Other Reactive Forces
- 7 Proper Techniques for Basic Bucking, Limbing, Pruning and Felling
- 8 Maintenance, Repair and Storage
- 9 Before Starting Work
- 10 Assembling the Chain Saw
- 11 Lubricating the Saw Chain and Guide Bar
- 12 The Chain Brake
- 13 Mixing Fuel and Refueling the Chain Saw
- 14 Starting the Engine
- 15 Shutting Off the Engine
- 16 Checking the Chain Saw
- 17 Adjusting the Carburetor
- 18 After Finishing Work
- 19 Transporting
- 20 Storing
- 21 Cleaning
- 22 Inspection and Maintenance
- 23 Troubleshooting Guide
- 24 Specifications
- 25 Combinations of Guide Bars and Saw Chains
- 26 Replacement Parts and Equipment
- 27 Disposal
- 28 Limited Warranty
- 29 Emission Control Warranty
- 30 Trademarks
- 31 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en el producto
- 5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 6 Contragolpe y otras fuerzas reactivas
- 7 Técnicas adecuadas para el tronzado, el desramado, la poda y la tala básicos
- 8 Mantenimiento, reparación y almacenamiento
- 9 Antes de empezar a trabajar
- 10 Armado de la motosierra
- 11 Lubricación de la cadena de aserrado y de la espada
- 12 El freno de cadena
- 13 Mezcla del combustible y carga de combustible en la motosierra
- 14 Arranque del motor
- 15 Apagado del motor
- 16 Revisión de la motosierra
- 17 Ajuste del carburador
- 18 Después de completar el trabajo
- 19 Transporte
- 20 Almacenamiento
- 21 Limpieza
- 22 Inspección y mantenimiento
- 23 Guía de solución de problemas
- 24 Especificaciones
- 25 Combinaciones de espadas y cadenas de aserrado
- 26 Piezas y equipos de repuesto
- 27 Eliminación
- 28 Garantía limitada
- 29 Garantía del sistema de control de emisiones
- 30 Marcas comerciales
- 31 Direcciones
0458-758-8621-B
51
English
21 Cleaning
► Clean the oil outlet duct (1), oil inlet bore (2) and groove
(3) with a brush, a slightly dampened cloth or resin
solvent, such as STIHL Resin Remover & Lubricant. Do
not use detergents.
► Clean the chain with a brush, a slightly dampened cloth or
resin solvent. Do not use detergents.
► Do not use a pressure washer to clean the guide bar or
chain or otherwise spray them with water or other liquids.
21.3 Cleaning the Air Filter
Very fine dust can collect in the air filter and block proper air
flow. This dust cannot be removed by simply brushing the air
filter or knocking it out. The air filter must be cleaned with the
STIHL special cleaner or another cleaning agent with a
pH value higher than 12.
To clean the air filter:
► Shut off the engine, @ 15.1.
► Engage the chain brake, @ 12.1.
► Open the filter cover lock (1) by turning it 1/4 turn counter-
clockwise.
► Remove the filter cover (2).
► Clean the area around the air filter (3) with a damp cloth
or soft brush.
► Remove the air filter.
► Rinse away coarse dirt from the outside of the air filter
under running water. Never spray the air filter with a
pressure washer.
► If the air filter is damaged, replace it.
► Spray the outside and inside of the air filter with STIHL
special cleaner or a cleaning agent with a pH value higher
than 12.
► Allow STIHL special cleaner or cleaning agent to act for
10 minutes.
► Use a soft brush to clean the outside of the air filter.
► Rinse the outside and inside of the air filter under running
water. Never spray the air filter with a pressure washer.
► Allow the air filter to air dry.
1
2
0000-GXX-2951-A0
3
3
0000-GXX-5819-A0
3
1
2