Instruction Manual

MS 461 R
English
30
N With the right hand, grip the slide
from above and loosen the
adjusting screw(2) with the left
hand
N Adjust cutting depth (arrow) and
tighten adjusting screw(2)
N Release the chain brake
A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the chain saw.
– The pitch(t) of the saw chain(1),
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
– The drive link gauge(2) of the saw
chain(1) must match the groove
width of the guide bar(3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
Chain scabbard
Your saw comes standard with a chain
scabbard that matches the cutting
attachment.
If you use guide bars of different lengths
on the saw, the length of the chain
scabbard must be matched to the guide
bar to reduce the risk of injury. It should
cover the full length of the guide bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.
Chain scabbard extensions
One chain scabbard extension is
required for guide bars longer than
35.4in (90cm). Two extensions are
required for guide bars longer than
47.2in (120cm).
Depending on original equipment, the
chain scabbard extension either comes
with the machine or is available as a
special accessory.
3443BA032 KN
2
Cutting Attachment
001BA248 KN
1
2
3
a
001BA244 KN