Instruction Manual

MS 461 R
English
29
N Push the spacers(4), cover(5), and
spiked bumper(6) onto the screws
and secure them with the
locknuts(7)
Mounting the depth limiter
N Mount the guide bar and saw chain
– see "Mounting the bar and chain"
N Slide the guide(1) over the bar and
screw in the screws(2)
N Push the slide(3) into place
N Fit the star screw with washer(5)
N Tighten screws(2)
N Pull the slide(3) forward as far as
possible
N Tighten star screw(4)
The cutting depth is infinitely adjustable
from just a few millimeters to approx.
8in (20cm).
Before each adjustment of the cutting
depth:
N Switch off the engine
N Engage the chain brake by pushing
the hand guard(1) toward the nose
of the guide bar – the saw chain is
blocked
N Place the chain saw on the ground
and position the front of the right
foot in the rear handle
3
2
4
5
3443BA030 KN
3
4
3443BA031 KN
Adjusting Cutting Depth