Owner's Manual

MS 441 C-M
English
32
Switching on the handle heating
system (depending on equipment
version)
N Set switch to F – to switch off, return
switch to the 0 position
Overheating during continuous use is
impossible. The heating system is
maintenance-free.
Positions of the Master Control lever
Stop 0 – engine off – ignition is switched
off
Operating position F – engine is
running or can start
Start } – this position is for starting the
engine
Adjusting the Master Control lever
To adjust the Master Control lever from
the operating position F to Start },
press and hold down the throttle trigger
lockout and throttle trigger
simultaneously – set Master Control
lever to Start } and simultaneously
release the throttle trigger and throttle
trigger lockout.
Simultaneously pressing the throttle
trigger lockout and blipping the throttle
trigger causes the Master Control lever
to jump from the start } position to the
operating position F.
Holding the chain saw
There are two ways to hold the chain
saw during starting.
Electric Handle Heating
219BA048 KN
Starting / Stopping the
Engine
219BA035 KN
0
STOP