Instruction Manual

MS 362
English
47
N Pull off the spark plug boot.
N Unscrew the spark plug.
Checking the spark plug
N Clean the spark plug if it is dirty
N Check the electrode gap (A) and
readjust if necessary – see
"Specifications"
N Use only resistor type spark plugs of
the approved range. See the
chapter "Specifications" in this
instruction manual
Correct the problems that have caused
fouling of the spark plug:
– too much oil in fuel mix;
– dirty air filter; or
– unfavorable running conditions, e.g.
operating at part throttle.
WARNING
To reduce the risk of fire and burn injury,
use only spark plugs authorized by
STIHL. Always press the spark plug
boot (1) firmly and securely onto the
spark plug terminal (2).
Do not use a spark plug with a
detachable SAE adapter terminal (3).
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
N Only use resistor type spark plugs
with solid, non-threaded terminals
Installing the Spark Plug
N Screw home the spark plug, fit the
boot and press it down firmly.
N Fit the shroud.
0001BA024 KN
000BA039 KN
A
2
0000-GXX-1830-A0
3
1
4903BA008 KN