Instruction Manual

MS 362
English
44
If There is a Noticeable Loss of Engine
Power
Removing the Shroud
N Move Master Control lever to
STOP, 0 or †.
N Push the hand guard forward – the
chain is locked.
N Open the twist locks (1) by turning
them 1/4 turn counterclockwise with
the combination wrench.
N Remove the shroud (2).
Removing the Air Filter
N Clean away loose dirt from around
the filter.
NOTICE
To avoid damaging the filter, do not use
tools to remove or install the air filter.
N Rotate the air filter a 1/4 turn
counterclockwise and lift it away in
the direction of the rear handle.
N Always replace damaged filters.
Cleaning the Air Filter
N Wash the filter in STIHL special
cleaner (special accessory) or a
clean, non-flammable solution (e.g.
warm soapy water). Rinse the filter
from the inside outwards under a jet
of water – do not use a pressure
washer.
N Dry the filter components – do not
expose to high temperatures.
N Do not impregnate the filter with oil.
N Reinstall the air filter.
Installing the Air Filter
N Place the air filter in position.
N Push the air filter towards the filter
housing and turn it clockwise at the
same time until it engages – the
"STIHL" name must be horizontal.
N Fit the shroud.
Cleaning the Air Filter
1
1
1
001BA199 KN
2
1.
5902BA010 KN
2.
5902BA011 KN
2.
1.