Instruction Manual

MS 362 C-M
English
43
NOTICE
High temperatures and oil can damage
the air filter. Filter efficiency can
deteriorate as a result.
– Allow air filter to dry without using
any external source of heat.
– Do not impregnate the filter with oil.
N Allow air filter to dry.
N Install the air filter.
Installing the Air Filter
N Place the air filter in position.
N Push the air filter towards the filter
housing and turn it clockwise at the
same time until it engages – the
"STIHL" name must be horizontal.
N Install the shroud – see "Shroud".
Exhaust emissions are controlled by the
design of the engine and components
(e.g. carburation, ignition, timing and
valve or port timing).
The chainsaw adjusts itself
automatically for optimum performance
during operation. Calibration enables
the saw to be adjusted faster for
optimum performance.
If the outside temperature is below –
10°C or the engine is cold:
N Start the engine and disengage the
chain brake.
N Warm up the engine by opening and
closing the throttle for about 1
minute.
N Shut off the engine.
Calibrate the chainsaw as follows:
N Set Master Control lever to
position }.
N Engage the chain brake.
N Start the engine without depressing
the throttle trigger. The engine runs
and the Master Control lever
remains in position }.
N Run the engine for at least 30
seconds but no more than 60
seconds without depressing the
throttle trigger.
5902BA011 KN
2.
1.
Engine Management M-Tronic
1
min
AB C
s> 30 s30-60 s
0000-GXX-4580-A0