Instruction Manual

MS 362 C-M
English
41
Anti-vibration elements
check XX
Have replaced by servicing dealer
1)
X
Air intake on fan housing Clean XX X
Cylinder fins Clean XX X
Carburetor
Check idle adjustment – saw chain must
not rotate
XX
If the saw chain continues moving when
the engine is idling, have your chainsaw
checked and repaired by your dealer
1)
X
Spark plug
Adjust electrode gap X
Replace after 100 hours of operation X
Accessible screws, nuts and bolts Tighten
2)
X
Chain catcher
check X
replace X
Safety information label replace X
1)
STIHL recommends STIHL dealers
2)
Firmly tighten down the cylinder base screws of chainsaws (3.4 kW or more) after 10 to 20 hours of operation.
The following information applies in normal operating conditions. The specified inter
-
vals must be shortened accordingly when working for longer than normal or under
difficult cutting conditions (extensive dust, highly resinous lumber, lumber from trop
-
ical trees, etc.). If you only use the tool occasionally, extend the intervals accordingly.
Before starting work At the end of work and/or daily Whenever tank is refilled Weekly Monthly Annually If faulty If damaged As required