Instruction Manual

MS 362 C-M
English
40
Maintenance and Care
The following information applies in normal operating conditions. The specified inter
-
vals must be shortened accordingly when working for longer than normal or under
difficult cutting conditions (extensive dust, highly resinous lumber, lumber from trop
-
ical trees, etc.). If you only use the tool occasionally, extend the intervals accordingly.
Before starting work At the end of work and/or daily Whenever tank is refilled Weekly Monthly Annually If faulty If damaged As required
Complete machine
Visual inspection (condition, leaks) XX
Clean X
Throttle trigger, throttle trigger lockout,
choke lever, stop switch, master control
lever (dependent on equipment)
Function test XX
Chain brake
Function test XX
Have checked by dealer
1)
X
Manual fuel pump (if present)
check X
Have repaired by a specialist dealer
1)
X
Fuel pick-up body / filter in fuel tank
check X
Clean, replace filter insert XX
replace XXX
Fuel tank Clean X
Lubricating oil tank Clean X
Chain lubrication check X
Saw chain
Check, pay attention to sharpness XX
Checking the chain tension XX
sharpen X
Guide bar
Check (wear, damage) X
Clean and turn over X
Deburr X
replace XX
Chain sprocket check X
Air filter
Clean XX
replace X