Instruction Manual

MS 362 C-M
English
32
Removing the Shroud
N To switch off the engine, move the
Master Control lever in the direction
of STOP or † – when released, the
Master Control lever springs back to
the run position F.
N Push the hand guard forward – the
chain is locked.
N Open the twist locks (1) by turning
them 1/4 turn counterclockwise with
the combination wrench.
N Remove the shroud (2).
Installing the Shroud
N Place the shroud in position.
N Close the twist locks by turning
them a 1/4 turn clockwise.
If There is a Noticeable Loss of Engine
Power
N Remove the shroud – see "Shroud".
Removing the Air Filter
N Clean away loose dirt from around
the filter.
NOTICE
To avoid damaging the filter, do not use
tools to remove or install the air filter.
N Rotate the air filter a 1/4 turn
counterclockwise and lift it away in
the direction of the rear handle.
N Always replace damaged filters.
Cleaning the Air Filter
N Knock out the filter.
N Spray outside of filter with STIHL
special cleaner or soapy water.
N Rinse outside of filter under warm
running water.
NOTICE
High temperatures and oil can damage
the air filter. Filter efficiency can
deteriorate as a result.
– Allow air filter to dry without using
any external source of heat.
– Do not impregnate the filter with oil.
N Allow air filter to dry.
N Install the air filter.
Installing the Air Filter
N Place the air filter in position.
N Push the air filter towards the filter
housing and turn it clockwise at the
same time until it engages – the
"STIHL" name must be horizontal.
N Install the shroud – see "Shroud".
Shroud
1
1
1
001BA199 KN
2
Cleaning the Air Filter
1.
5902BA010 KN
2.
5902BA011 KN
2.
1.