Instruction Manual

The following information applies in normal operat‐
ing conditions. The specified intervals must be
shortened accordingly when working for longer
than normal or under difficult cutting conditions
(extensive dust, highly resinous lumber, lumber
from tropical trees, etc.). If you only use the tool
occasionally, extend the intervals accordingly.
Before starting work
At the end of work and/or daily
Whenever tank is refilled
Weekly
Monthly
Annually
If faulty
If damaged
As required
Check or replace
1)
X
Chain catcher check X
replace
X
Safety information label replace X
1)STIHL recommends STIHL dealers2)Firmly tighten down the cylinder base screws of chainsaws
(3.4 kW or more) after 10 to 20 hours of operation.
30 Main Parts
19
22
21
23
24
17
18
14
15
16
13
12
11
10
6
5
3
4
1
8
7
#
0001BA029 KN
9
2
20
1 Shroud lock
2 Handle heating switch (depending on model)
3 Spark plug boot
4 Shutter (summer and winter operation)
5 Decompression valve
6 Chain brake
7 Chain sprocket
8 Chain sprocket cover
9 Chain catcher
10 Side chain tensioner
11 Spiked bumper
12 Guide bar
13 Oilomatic chain
14 Oil filler cap
15 Muffler
16 Front hand guard
17 Front handle (handlebar)
18 Starter grip
19 Fuel filler cap
20 Master Control Lever
21 Throttle trigger
22 Throttle trigger lockout
23 Rear handle
24 Rear hand guard
# Serial number
31 Specifications
31.1 Engine
STIHL single cylinder two-stroke engine
31.1.1 MS 362 C-M
Displacement:
59.0 cc
Bore: 47 mm
Stroke: 34 mm
30 Main Parts English
0458-154-8321-C 37