Owner's Manual

48
English / USA
MS 341, MS 361, MS 361 C
Starter Grip without ElastoStart
: Use a screwdriver to pry the rope
out of the starter grip.
: Remove the remaining rope from
the rotor and grip.
: Thread the new rope through the
starter grip and tie a simple
overhand knot.
: Pull the knot back into the grip.
Starter Grip with ElastoStart*
: Use a screwdriver to pry the rope
out of the starter grip.
: Remove the remaining rope from
the rotor and grip.
: Thread the new rope through the
top of the starter grip.
* see “Guide to Using this Manual”
All Versions
: Thread the rope through the top of
the guide bush (5), pull it through
the rotor (6) and secure it with a
simple overhand knot.
: Coat rope rotor bearing bore with
resin-free oil.
: Slip rotor over the starter post (7) –
turn it back and forth to engage
anchor loop of the rewind spring.
213BA018 KN
213BA019 KN
6
7
213BA020 KN
5