Owner's Manual

MS 291 C-Q
English
26
N Fit the nut (5) and screw it by hand
onto the headless pin as far as it will
go
Releasing the chain brake
N Release the chain brake by pushing
the hand guard (9) against the front
handle
Fitting the saw chain
N Fit the saw chain – starting at the
nose of the guide bar – pay attention
to the position of the tensioning gear
and the cutting edges
N Turn tensioning gear (4) to the right
as far as possible
N Turn the guide bar so that the
tensioning gear faces the user
N Place the saw chain on the chain
sprocket (10)
N Position guide bar – the long middle
mounting stud (11) protrudes
through the hole in the tensioning
gear – the heads of the two short
mounting studs protrude into the
oblong hole of the guide bar
N Press the throttle trigger lockout to
release the chain brake
N Guide the drive link into the bar
groove (see arrow) and turn the
tensioning gear to the left as far as
possible
5
133BA030 KN
133BA032 KN
9
Put on protective gloves – risk of
injury by the sharp cutters
4
133BA031 KN
11
10
133BA033 KN
133BA034 KN