Owner's Manual

MS 261 C-Q
English
44
Models with ElastoStart
N Pry the cap out of the starter grip.
N Remove the remaining rope from
the rotor and starter grip.
N Thread the new rope through the
starter grip and tie a simple
overhand knot.
N Pull the knot back into the grip.
N Refit the cap in the grip.
Models with Easy2Start
N Remove the remaining rope from
the rotor and starter grip.
N Thread the new rope through the
starter grip and tie one of the knots
shown.
All models
N Thread the end of the rope through
the top of the guide bushing (1) and
rope rotor (2) and secure it with a
simple overhand knot.
N Coat the rope rotor bearing bore
with non-resinous oil.
N Slip the rotor over the starter
post (3) – turn it back and forth to
engage the anchor loop of the
rewind spring.
5902BA019 KN
146BA018 KN
151BA021 KN
2
3
5902BA021 KN
1