Instruction Manual
Table Of Contents
- STIHL MS 261 C-M
- 1 Guide to Using this Manual
- 2 Safety Precautions
- 3 Reactive Forces
- 4 Working Techniques
- 5 Cutting Attachment
- 6 Mounting the Bar and Chain (side chain tensioner)
- 7 Mounting the Bar and Chain (quick chain tensioner)
- 8 Tensioning the Saw Chain (side chain tensioner)
- 9 Tensioning the Saw Chain (quick chain tensioner)
- 10 Checking Chain Tension
- 11 Fuel
- 12 Fueling
- 13 Chain Lubricant
- 14 Filling Chain Oil Tank
- 15 Checking Chain Lubrication
- 16 Chain Brake
- 17 Winter Operation
- 18 Electric Handle Heating
- 19 Starting / Stopping the Engine
- 20 Operating Instructions
- 21 Oil Quantity Control
- 22 Taking Care of the Guide Bar
- 23 Shroud
- 24 Air Filter System
- 25 Cleaning the Air Filter
- 26 M-Tronic
- 27 Spark Plug
- 28 Storing the Machine
- 29 Checking and Replacing the Chain Sprocket
- 30 Maintaining and Sharpening the Saw Chain
- 31 Maintenance and Care
- 32 Minimize Wear and Avoid Damage
- 33 Main Parts
- 34 Specifications
- 35 Ordering Spare Parts
- 36 Maintenance and Repairs
- 37 Disposal
- 38 EC Declaration of Conformity
5902BA013 KN
► Pull off the spark plug boot.
► Clean away loose dirt from around the spark
plug.
5902BA014 KN
1
► Insert the combination wrench through the
grommet (1) and turn it as necessary to
engage the spark plug's hexagon.
► Push the combination fully home against the
cylinder.
► Unscrew the spark plug.
27.2 Checking the Spark Plug
000BA039 KN
A
► Clean dirty spark plug.
► Check electrode gap (A) and readjust if neces‐
sary – see "Specifications".
► Rectify the problems which have caused foul‐
ing of the spark plug.
Possible causes are:
–
Too much oil in fuel mix.
–
Dirty air filter.
–
Unfavorable running conditions.
1
000BA045 KN
WARNING
Arcing may occur if the adapter nut (1) is loose
or missing. Working in an easily combustible or
explosive atmosphere may cause a fire or an
explosion. This can result result in serious inju‐
ries or damage to property.
► Use resistor type spark plugs with a properly
tightened adapter nut.
27.3 Installing the spark plug
5902BA016 KN
► Insert the spark plug through the grommet and
screw it in by hand.
► Tighten down the spark plug, fit the boot and
press it down firmly.
► Install the shroud – see "Shroud".
28 Storing the Machine
For periods of 3 months or longer
► Drain and clean the fuel tank in a well ventila‐
ted area.
► Dispose of fuel properly in accordance with
local environmental requirements.
► Run the engine until the carburetor is dry – this
helps prevent the carburetor diaphragms stick‐
ing together.
► Remove the saw chain and guide bar, clean
them and spray with corrosion inhibiting oil.
► Thoroughly clean the machine – pay special
attention to the cylinder fins and air filter.
English 28 Storing the Machine
32 0458-153-0121-C