Instruction Manual

There is possibly a non-combustible fuel-air mix‐
ture in the combustion chamber of the engine
that is too rich– the engine has flooded.
► Remove the spark plug – see "Spark Plug".
► Dry the spark plug
► Keep the chain saw on the ground
► Push the Master Control lever as far as stop in
direction of STOP or † and hold it there.
WARNING
An ignition spark may occur if the Master Control
lever is not held against STOP or †.
► Actuate the starter several times
► Release the Master Control lever – it springs
back to the run position F.
► Refit the spark plug – see "Spark Plug".
► Hold and start your saw as described.
20 Operating Instructions
20.1 During the break-in period
A factory new machine should not be run at high
revs (full throttle off load) for the first three tank
fillings. This avoids unnecessarily high loads dur‐
ing the break-in period. As all moving parts have
to bed in during the break-in period, the frictional
resistances in the shortblock are greater during
this period. The engine develops its maximum
power after about 5 to 15 tank fillings.
20.2 During work
NOTICE
Open the throttle only when the chain brake is
off. Running the engine at high revs with the
chain brake engaged (chain locked) will quickly
damage the engine and chain drive (clutch,
chain brake).
20.2.1 Check chain tension frequently
A new saw chain must be retensioned more fre‐
quently than one that has been in use already for
an extended period.
20.2.2 Chain cold
Tension is correct when the chain fits snugly
against the underside of the bar but can still be
pulled along the bar by hand. Retension if neces‐
sary – see "Tensioning the Saw Chain".
20.2.3 Chain at operating temperature
The chain stretches and begins to sag. The drive
links must not come out of the bar groove on the
underside of the bar – the chain may otherwise
jump off the bar. Retension the chain – see "Ten‐
sioning the Saw Chain".
NOTICE
The chain contracts as it cools down. If it is not
slackened off, it can damage the crankshaft and
bearings.
20.2.4 After a long period of full-throttle oper‐
ation
After a long period of full-throttle operation, allow
engine to run for a while at idle speed so that the
heat in the engine can be dissipated by flow of
cooling air. This protects engine-mounted com‐
ponents (ignition, carburetor) from thermal over‐
load.
20.3 After finishing work
► Slacken off the chain if you have retensioned it
at operating temperature during work.
NOTICE
Always slacken off the chain again after finishing
work. The chain contracts as it cools down. If it is
not slackened off, it can damage the crankshaft
and bearings.
20.3.1 Short-term storage
Wait for engine to cool down. Keep the machine
with a full tank of fuel in a dry place, well away
from sources of ignition, until you need it again.
20.3.2 Long-term storage
See "Storing the machine"
21 Oil Quantity Control
Adjustable flow oil pump is a special option.
Different quantities of oil are required for different
bar lengths, types of wood and cutting techni‐
ques.
001BA157 KN
1
English 20 Operating Instructions
28 0458-153-8321-C