Operation Manual

98 MS 241 C
: Position antivibration element (1)
against front handle and cylinder
: Screw in the screw (2) and
tighten it
: Coat screw (3) with Loctite,
screw in and tighten, b 16
– Reassemble remaining parts in
reverse order
10.3.2 Stop buffer
The stop buffers are installed
between crankcase and tank
housing on the ignition and clutch
side.
– Remove the tank housing,
b 13.11.5
: Pry out stop buffers (1) on the
ignition and clutch sides
2410RA309 TG
13
2
2410RA310 TG
1
– Replace stop buffer
Installation
– Orient the stop buffer (1) on both
sides – the conical pegs (arrow)
facing the crankcase
– To simplify installation, coat the
conical pegs with STIHL press
fluid, b 16
: Press the stop buffers (1) with the
pegs on the inside of the
crankcase completely into holes
– to simplify assembly, twist the
stop buffers while pressing them
in
The conical pegs must enclose the
holes completely.
– Reassemble remaining parts in
reverse order
2410RA311 TG
1
2410RA312 TG
10.3.3 Filter base buffers
– Remove filter base, b 13.3
: Remove screw (1)
: Push tank housing (2) down
slightly and hold it there
: Press out the buffers (1) on the
underside (arrows)
– Check buffers (1) and replace if
necessary
2310RA249 TG
1
2
2410RA313 TG
1 1