Operation Manual

97MS 241 C
Installation
: Push retainer (1) with the small
nipple into the hole in the front
handle (2)
: Twist spring (3) onto the
peg (arrow) as far as it will go
: Hook retainer (arrow) onto
bearing plug (1)
: Push bearing plug (1) into the
spring as far as it will go
– Install the front handle, b 10.4
2310RA244 TG
3
1
2
2310RA245 TG
1
: Position bearing plug (1) against
cylinder
: Coat screw (2) with Loctite,
screw in and tighten, b 16
– Reassemble remaining parts in
reverse order
10.3.1 Antivibration element on
handlebar, version with
heating
: Remove screws (1) and (2)
: Remove the antivibration
element (3) completely
2410RA306 TG
1
2
2410RA308 TG
31
2
: Twist out bearing plug (1) and
unhook retainer (arrow)
: Twist out spring (2) and pull out
retainer (arrow)
Installation
: Insert retainer (1) with the nipple
in the holder (2)
: Twist spring (2) onto the peg
: Hook retainer (arrow) onto
bearing plug (1)
: Twist bearing plug (1) into the
spring (2) as far as it will go
0001RA219 TG
1
2
5902RA246 TG
2
1
0001RA219 TG
1
2