Operation Manual

94 MS 241 C
10. Maintaining the antivibration elements
The front handle / tank housing and
crankcase are connected by
vibration-damping springs, rubber
buffers and stop buffers.
Damaged springs rubber buffers
and stop buffers must always be
replaced.
10.1 Antivibration element on
oil tank
The antivibration elements are
located in the area of the oil tank
and are fastened to the bottom of
the machine.
– Remove the front handle,
b 10.4, versions with heating,
b 10.4.1
: Remove screw (1)
: Remove the chain catcher (2)
– Remove the tank housing,
b 13.11.5
2410RA300 TG
2
1
: Twist out spring (1) with bearing
plug (2)
– Inspect spring with plug, replace
if necessary
Installation
Bearing plug (1) must be twisted
into the spring (2) as far as it will go.
: Twist spring (2) with bearing
plug (1) into the mount (arrow) as
far as it will go
– Install the tank housing,
b 13.11.5
2310RA233 TG
2
1
2310RA234 TG
2
1
: Push the chain catcher (3) into
the mount so that it engages
under the bumper strip (2)
: Screw in the screw (1) and
tighten it
– Reassemble remaining parts in
reverse order
10.2 Antivibration element on
fuel tank
: Remove screw (1)
2410RA301 TG
3
1
2
2410RA302 TG
1