Operation Manual

93MS 241 C
Make certain that the rewind
spring (1) is inserted completely
and the outer anchor loop is seated
in the anchor loop mount (arrow), if
necessary, press the rewind spring
completely into the mount in the fan
housing.
– Secure the rewind spring so that
it cannot pop out
– Install the rope rotor, b 9.5
– Reassemble remaining parts in
reverse order
2310RA229 TG
1
Reinserting a popped out rewind
spring into the frame
In versions with ErgoStart, the
rewind spring mount sits lower, thus
the rewind spring can only be
inserted directly into the fan housing
premounted in a frame.
If the rewind spring pops out during
installation, fit it in the frame as
follows:
: Insert anchor loop in the
recess (arrow) of the frame
: Fit the rewind spring (1) in the
frame in a circular fashion,
working in counterclockwise
direction while holding the
inserted turns of the spring in
place
The further course of action is the
same as for "Installing a new rewind
spring" in versions with ErgoStart.
5902RA608 TG
1